After years of wanting to build a drag car the chance has finally come, the build is kind of slow but its moving and hope to have the car on the track come next year. The build is based of a rsx-s and my goal is to run low 10.XX and this is what I have done so far.

*turbo kit
FR manifold T3 twin 44mm
6765 JB
custom intercooler 22x12x4.5
3 inch piping hot and cold

*engine
erl sleeved 2.1
cp 9:1
Carrillo pro h
pp head with ferrea valve train
k24 rockers
1/2 head studs
bc stg 2 N/A cams
s2k oil pump

*fuel system
ID2000
twin 044
-10 feed
-8 return

*drive train
ppg dog box 1-4
quaife lsd
exedy twin disk
dss 3.9

car with the old setup


taking out the old block to put in the erl sleeved block


adding the second 44mm to help control the 6767


all done


exedy twin disk


got the motor back in and ready to start welding up the ic


12x24x4.5 ic




alum trunk floor to hold the new surge tank and battery box


new surge tank

 

nice build keep up the good work

 

Good to see another DC5, looking forward to the first pass

 

I love seeing more DC5's get built! Crazy how no one has hit 9's in one yet!

 

thanks guys

 

almost finished the fuel system up

 

is the fuel lines inside the trunk/hatch area???

 

it goes through the floor then under the car

 

do you plan on running at any nhra tracks

 

what ever track is local

 

im pretty sure the any part of the fuel system being inside the car like that is a nono man hate to say it, but i might be wrong

 

your right
1:5 FUEL SYSTEMS
Location: All fuel tanks, lines, pumps, valves, etc. must be outside
of the driver’s compartment and within the confines of the frame
and/or steel body

 

alot of tracks will turn you away because of this man

but i think it looks pretty damm clean

 

thanks

 

I find some of these rules funny. This guys fuel system may not be legal for NHRA, but this guys fuel system was legal.



I could be completely wrong, but the left side of the container looks to be a fuel tank and the right side appears to be the water/ice reservoir.

 

i just did some quick research and all i would have to do is enclose the swirl pot in a box or make a bulk head of some sort like this

http://i641.photobucket.com/albums/u...a/000_0354.jpg

 

nice build.