Front/Rear light weight custom fabbed bumper supports for 89 civic hatch
Thread Starter
Junior Member
Joined: Sep 2003
Posts: 317
Likes: 0
From: Albuquerque, NM, USA
Front/Rear light weight custom fabbed bumper supports for 89 civic hatch
As far as I know these only fit civic ef hatchs from 88-91. These were used on an ITE SCCA car and have no damage from hits. They are intended to be used with the factory OEM bumper skins and are held on by 3 dzus clips and the four screws on the sides.
These are one off and were fabricated by Adam Hammill of HAMFAB here in New Mexico. They are tig welded and use the OEM mounting holes/hardware.
These are one off and were fabricated by Adam Hammill of HAMFAB here in New Mexico. They are tig welded and use the OEM mounting holes/hardware.
Last edited by brokenojoke; May 3, 2012 at 04:01 PM.
Here's some pics
Thread Starter
Junior Member
Joined: Sep 2003
Posts: 317
Likes: 0
From: Albuquerque, NM, USA
Re: Front/Rear light weight custom fabbed bumper supports for 89 civic hatch
$400 shipped for both the front and the rear.
I'll include all the dzus clips I still have also.
I'll get some photos of the rear one on here asap.
I'll include all the dzus clips I still have also.
I'll get some photos of the rear one on here asap.
Thread
Thread Starter
Forum
Replies
Last Post
flowgetta
Southern California (Sales)
2
Nov 5, 2008 03:04 PM
Plum_civicEK
Honda Civic / Del Sol (1992 - 2000)
30
Feb 9, 2007 09:48 AM