SOHC into DA
has anyone ever done this? so im picking up a da shell for next to nothing, i have a complete y7 with si trans just sitting in my garage, my question is there any "stock" mounts that would work? the tranny is a hydro si was planning on using the hydro to cable convertion as a cable si d series trans is hard to come by. i would think my stock crx linkages would work and the rear t braket/mount from a crx would work. anyone have any experience? and ya i know its gonna be sloooowwww and i dont care, just want a dd.
is that jap spec? cause if all goes right ill only be not even 500 into this and the shell is pretty clean, just want something to tool around town with, id rather put my money into my other project, you know of any distributors for the da5 mounts? ebays not pulling up anything and i dont really know where else to look
Trending Topics
Well the weight to power ratio of a single cam in an integra will cause the gas mileage to be sufficiantly worse than if it were in a CRX. Sell it for a B18a/b, they go for like $500-$700
It'll be different, I'll give you that, but it will be like a b16 running on 3 cylinders lol.
I say, swap in the single cam, get JDM 1 piece headlights, JDM thin side moldings, and a DA5 vin tag for the engine bay. Now that would be different, because DA5's are as rare as pale chicks at the Jersey shore haha
I say, swap in the single cam, get JDM 1 piece headlights, JDM thin side moldings, and a DA5 vin tag for the engine bay. Now that would be different, because DA5's are as rare as pale chicks at the Jersey shore haha
itd be hard to believe that it would be worse then my hf when it was stock, i have the si trans so itll have a little gear to make up for some of the power loss
Thread
Thread Starter
Forum
Replies
Last Post
AudioXtremes
Honda CRX / EF Civic (1988 - 1991)
7
Jul 24, 2006 11:02 AM



, this is dd gas sipper
