Got the following for sale. Decided to go another route with the car so selling most of everything in the engine bay. And other parts I was accumulating to start my bottom end build. Will get pics of everything else I dont have tomorrow if I have time. Located in York, PA Looking for J swap parts.

B18C GSR block bored to 81.5mm(hasnt been used sinced bored), gsr crank, girdle(have to check), used eagles, new ACL race bearings $750obo You choose your pistons and assemble the bottom end your way.

Moroso Oil pan with -10an fitting. $100


Hasport Mounts for DC/EG $250, for an extra $25 will include rear T-Bracket

FIC 900s just back from being inspected and cleaned. Clips I have to remove from my harness yet.

Black AEM fuel rail with B&M FPR $115 (believe I have another B&M for parts that i took the screws from but have to check. If i do I will include this to. For an extra $50 I will include a black -6an line to go from stock fuel filter to aem rail with fittings.


Also 1st gen Skunk2 intake manifold with stock GSR TB, bracket, and all sensors $160. In above picture.


Russels Adapter Fitting -10 Flare x 1/2" NPT $7


(2)Vibrant SS T-Bolt Clamps 3.01"-3.25" $15obo


(2)Vibrant 2.5" SS V-band flanges $35 for the pair or $20each


HKS Style BOV on pipe w/ extra aluminum flange $30


-4AN oil line $35


pfab log manifold, Turbonetics Evolution 38mm wastegate w/2 springs, and dump tube. $450obo



2.5" Intercooler piping, Black Mishimoto S-Line Intercooler(Installed on car and next day bent a rod ), mostly vibrant couplers(couple ebay), clamps, ebay bov. $475obo Old pics with old couplers.




Arospeed Catch Can $60obo

 

bump