RS Machines SLEEVED B16A Block/Crank
Thread Starter
Honda-Tech Member
Joined: Sep 2002
Posts: 1,856
Likes: 0
From: Little Rock, AR
RS Machines SLEEVED B16A Block/Crank
Asking $800 OBO for the block with the crankshaft, oil & water pumps, timing belt tensioner and sensors all included as shown. It would need to be bored due to some scoring in the sleeve. The current bore is 81mm.
The crank is perfect. When I removed the rods, all bearings were intact and in place. The engine dropped a valve, so it completely wasted the head and one piston leaving some scratches in the sidewall of one cylinder. My suggestion would be to buy 84mm or larger pistons and have it bored to accommodate them.
The crank is perfect. When I removed the rods, all bearings were intact and in place. The engine dropped a valve, so it completely wasted the head and one piston leaving some scratches in the sidewall of one cylinder. My suggestion would be to buy 84mm or larger pistons and have it bored to accommodate them.
Thread
Thread Starter
Forum
Replies
Last Post
Boostfed
For Sale
20
Jan 10, 2006 09:08 PM
