NC FS/FT 2000 Civic Coupe Built Allmotor street screamer
posted for my buddy.
Name: Nick
Location: Lenoir, NC
Means of Contact (PM? Email? Phone?): rxspeed88@yahoo.com or 8286121712
Year - Make - Model - Trim Level : 2000 ej8 coupe ex
Miles: 154k
Price: 6500 obo
Title Type: Clear
Activities: Daily Beater , McDonalds drive thru
Smoked In?: No
Picture Included In Message: Box? (MUST have one picture minimum or thread will be deleted): Yes
The Bad: has cracked rear bumper (2in in corner). front bumper was cut for intercooler. The A pillar on drivers side has 2 holes from gauge pod. some small kneecap dents from people leaning over the fenders. nothing major and i need a bike!
The Good: Fully built from oil pan to valve cover. car is stout.
I want another street bike and I just got a new dd so its time for the girl to go to someone else. I dont need to sell it and i really dont care if it does Ive got the craving for another street bike. ill take trade on anything other than a kawasaki and its gotta be 750cc or better. Ive had my fill on 600's. A busa is what i really want.
LS/VTEC setup. 00 si Head.81.5mm bore. Wiseco 13:1 forged pistons. eagle rods. acl race bearings. Arp top and bottom end studs. kms/super tech valve train. Crower stg 3 plus cams. Aem cam gears. Aem fuel rail. Edelbrock victor x. Tri y header. Head has been worked a bit. Bowls have been worked by Harrington machine. Cometic gasket. 10 gallon fuel cell in trunk. Aeromotive A1000 fuel pump, aeromotive fuel regulator. b16 trans. NO Grinds. stg 5 clutch (not that bad) catch can and other small stuff. It's set up for direct port nitrous but I havent finished the lines yet. Made 230wheel and 154 tq at RAW PERFORMANCE. Sitting on rota grids. Has dropzone coilovers around. tires have less than 1500 miles on them. Hankook ventus. Car is tuned on Crome. But ive got a neptune rtp setup as well.





Ive got tons of pics. just let me know what you need.
Name: Nick
Location: Lenoir, NC
Means of Contact (PM? Email? Phone?): rxspeed88@yahoo.com or 8286121712
Year - Make - Model - Trim Level : 2000 ej8 coupe ex
Miles: 154k
Price: 6500 obo
Title Type: Clear
Activities: Daily Beater , McDonalds drive thru
Smoked In?: No
Picture Included In Message: Box? (MUST have one picture minimum or thread will be deleted): Yes
The Bad: has cracked rear bumper (2in in corner). front bumper was cut for intercooler. The A pillar on drivers side has 2 holes from gauge pod. some small kneecap dents from people leaning over the fenders. nothing major and i need a bike!
The Good: Fully built from oil pan to valve cover. car is stout.
I want another street bike and I just got a new dd so its time for the girl to go to someone else. I dont need to sell it and i really dont care if it does Ive got the craving for another street bike. ill take trade on anything other than a kawasaki and its gotta be 750cc or better. Ive had my fill on 600's. A busa is what i really want.
LS/VTEC setup. 00 si Head.81.5mm bore. Wiseco 13:1 forged pistons. eagle rods. acl race bearings. Arp top and bottom end studs. kms/super tech valve train. Crower stg 3 plus cams. Aem cam gears. Aem fuel rail. Edelbrock victor x. Tri y header. Head has been worked a bit. Bowls have been worked by Harrington machine. Cometic gasket. 10 gallon fuel cell in trunk. Aeromotive A1000 fuel pump, aeromotive fuel regulator. b16 trans. NO Grinds. stg 5 clutch (not that bad) catch can and other small stuff. It's set up for direct port nitrous but I havent finished the lines yet. Made 230wheel and 154 tq at RAW PERFORMANCE. Sitting on rota grids. Has dropzone coilovers around. tires have less than 1500 miles on them. Hankook ventus. Car is tuned on Crome. But ive got a neptune rtp setup as well.





Ive got tons of pics. just let me know what you need.
Thread
Thread Starter
Forum
Replies
Last Post
MilanoRed EG6
Motorcycles
5
Aug 22, 2007 03:30 PM



