Hey guys im sure this info is somewhere out there but I just cannot seem to find it. anyways I have a motor/tranny out of a DA integra its complete intake manifold/sensors etc..

my question is

Which axles/shiftlinkage can I use.... I was told that the shiftlinkage is too long.. is there any way to modify this if you are a very good welder (which i am) and also what axles can i use?

thanks!

 

use the da axles be sure and remove the inner hub ring. you can modify the da linkage, you have to make sure the rods back up perfectly or the linkage will be screwed up.

 

also check out the faq section b-swap info is in there