hello friends of h-t. I have just recently finished building a b18a1 engine with forged internals and a lowered compression ratio for my bolt on modifications for a forced induction setup. I am in the prime to begin mating the transmission with the engine and i recently came across a very good bargain for a obd2 wiring harness for a type r engine. The guy selling it to me said that it is possible to run an obd2 wiring harness with an obd0 engine and that all that would need to be necessary is some repinning work on the dizzy and and possibly the transmission, not to mention a very big wire diagram and some good ole research. well like anyone else I have tried some research and have either failed epicly or I am not looking hard enough. Would anyone care to shed some light in my direction on the possible layout of this setup and if it is even possible. when all else fails fabricated, right?

 

It it helps. It's for a manual trans and the dizzy is obd0 and also I will be using hondata