FS: D16y7 Block, D16y8 Head, D15b Intake Manifold - Atlanta, GA
Thread Starter
Honda-Tech Member
Joined: Nov 2002
Posts: 538
Likes: 0
From: Atlanta, GA
FS: D16y7 Block, D16y8 Head, D15b Intake Manifold - Atlanta, GA
All,
I pulled this motor from a 97 EX Coupe w/ auto transmission not too long ago and swapped in a D15b. This motor failed to pass smog (due to a misfire) about 1 year ago , and has not been started since. The motor did start, idle, and drive before it was set aside. To the best of my knowledge something is wrong with the crankshaft, though I don't know exactly what the problem is. I have since swapped in a D15b, and used any parts I needed from this motor in the swap. This motor should be assumed to have no sensors, plugs, wires, hoses, etc... I used the D16y8 intake manifold, distributor, and 2-stage VTEC solenoid in the swap also, so the parts they replaced are on this motor.
To be exact, there may be extra parts attached and included, but I am specifically listing for sale the following:
D16y7 Block w/ likely crankshaft issue
D16y8 Head w/ 3-stage VTEC solenoid
D15b Intake Manifold
Asking Price: $200 OBO for the combination. I will part out if I can confirm a buyer for all 3 components.
I am located in Chamblee, GA. Local pickup is welcomed, or I will ship at Buyer's cost.
I pulled this motor from a 97 EX Coupe w/ auto transmission not too long ago and swapped in a D15b. This motor failed to pass smog (due to a misfire) about 1 year ago , and has not been started since. The motor did start, idle, and drive before it was set aside. To the best of my knowledge something is wrong with the crankshaft, though I don't know exactly what the problem is. I have since swapped in a D15b, and used any parts I needed from this motor in the swap. This motor should be assumed to have no sensors, plugs, wires, hoses, etc... I used the D16y8 intake manifold, distributor, and 2-stage VTEC solenoid in the swap also, so the parts they replaced are on this motor.
To be exact, there may be extra parts attached and included, but I am specifically listing for sale the following:
D16y7 Block w/ likely crankshaft issue
D16y8 Head w/ 3-stage VTEC solenoid
D15b Intake Manifold
Asking Price: $200 OBO for the combination. I will part out if I can confirm a buyer for all 3 components.
I am located in Chamblee, GA. Local pickup is welcomed, or I will ship at Buyer's cost.
Last edited by Team 4R; May 23, 2011 at 05:18 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Team 4R
Southeast (Sales)
9
May 26, 2011 05:22 PM
Dasfinc
For Sale
17
May 14, 2010 10:31 AM
