Hello fellow EF drivers! :-D

Last week I purchased a very clean 1990 Civic STD hatch.

She is very clean with no rust and no major dents....... just missing lots of stuff :dead:

The entire dash harness,engine harness and ignition harness were removed

by the PO and most of it is hacked up and spliced to hell :evil: So I went

ahead and bought the whole front wiring and dash board setup out of an 90

CRX Si.

Judging by the very large pile of wires and connectors in the trunk I have a large job to do 8|

Any tips on how to make this nice , clean and as pain free as possible?

 

Anything else that I should do while I have the firewall area bare?


The will be getting a b18 in the next few months fyi ...

 

start from the firewall and work your way to the rear.

 

Search for some wire tuck threads. Im sure you'll see how and where most wires and connectors go. Plus you might actually do some tucking while your there.