FS/FT 97 civic hatch w/ JDM ITR Swap
97' civic cx hatchback with about 140K on the body
98 spec JDM Type R engine and trans. About 15K after build
build specs
Block was bored and honed .02 over and hot tanked
micro-polished and balanced LS crank
LS Eagle Rods with APR Rod bolts
CP 12.5:1 pistons
Oil squirter plug kit
All bearings replaced with ACL race bearing
All upper and lower gaskets replaced with OEM Honda brand
Stock JDM ITR head
APR Head studs
Stock 98+ ITR Stainless Steel Header w/ heat shield
K-Teller 2.5” full Stainless Steel exhaust w/ magnaflow high flow cat and muffler
Password JDM dry carbon fiber Power Chamber intake
P28 with Hondata s100 with recent Air/Fuel tune
New OEM oil Pump
ITR Axles
Has Air Conditioning and works great
Replaced Parts
B&M sport shifter
New Hardened shift linkage bushings
New B-series Shift linkage
Innovative motor mount kit
New OEM B series mount brackets
Suspension
10 month old Tien Type Flex Coilovers (Paid $1800 with the EDFC)
EDFC (Electronic Dampening Force Controller) installed
Buddy Club P-1 Racing Camber Kit (front and Rear)
Password JDM 3 point front strut tower bar
custom Stainless Steel rear pillar bar
Spoon(?) rear lower arm bar
Interior
OEM type R shift ****
99 Si gauge cluster
other than that its bone stock
Exterior
Color DAP
Appearance is bone stock. Nothing cosmetic is done to it yet
The motor has about 15K on it since the rebuild and has not been abused at all. Oil has been change 5 times since the build and I have used nothing but Mobile 1, synthetic 5-W30. It was tuned on 93 pump gas and that is the only type I’ve filled it with. The swap is very clean and done right. The motor is very strong for what it is. It was dyno’d at 195.6 hp and 136.4 tq.
The interior is in good shape other than a cut on the dashboard that was there when I bought the car. Its noticeable but not bad. The exterior is still completely stock as stated above. I spent all my money on mechanics then never got around to making it look good. The car has never been in a wreck to the best of my knowledge and it is in very decent shape compared to whats out there. The worst thing about it is the hood which is bent a little. The fenders and bumper have no damage so I don’t know what happened to the hood. Other than that, just typical little scratches and dings but nothing serious.
I love this car and I’m still not convinced I want to get rid of it. The things I don’t like about it anymore is the noise and the rid stiffness. Because I still love the car and don’t have to get rid of it, I will probably only sell it if the right deal comes along.
Im asking $6000 obo and the main trade I would be interested in is a Tacoma 4x4 ext. cab
or a Subaru wrx or 2.5 RS
If anyone is interested please feel free to make an offer.
PM me for pictures
98 spec JDM Type R engine and trans. About 15K after build
build specs
Block was bored and honed .02 over and hot tanked
micro-polished and balanced LS crank
LS Eagle Rods with APR Rod bolts
CP 12.5:1 pistons
Oil squirter plug kit
All bearings replaced with ACL race bearing
All upper and lower gaskets replaced with OEM Honda brand
Stock JDM ITR head
APR Head studs
Stock 98+ ITR Stainless Steel Header w/ heat shield
K-Teller 2.5” full Stainless Steel exhaust w/ magnaflow high flow cat and muffler
Password JDM dry carbon fiber Power Chamber intake
P28 with Hondata s100 with recent Air/Fuel tune
New OEM oil Pump
ITR Axles
Has Air Conditioning and works great
Replaced Parts
B&M sport shifter
New Hardened shift linkage bushings
New B-series Shift linkage
Innovative motor mount kit
New OEM B series mount brackets
Suspension
10 month old Tien Type Flex Coilovers (Paid $1800 with the EDFC)
EDFC (Electronic Dampening Force Controller) installed
Buddy Club P-1 Racing Camber Kit (front and Rear)
Password JDM 3 point front strut tower bar
custom Stainless Steel rear pillar bar
Spoon(?) rear lower arm bar
Interior
OEM type R shift ****
99 Si gauge cluster
other than that its bone stock
Exterior
Color DAP
Appearance is bone stock. Nothing cosmetic is done to it yet
The motor has about 15K on it since the rebuild and has not been abused at all. Oil has been change 5 times since the build and I have used nothing but Mobile 1, synthetic 5-W30. It was tuned on 93 pump gas and that is the only type I’ve filled it with. The swap is very clean and done right. The motor is very strong for what it is. It was dyno’d at 195.6 hp and 136.4 tq.
The interior is in good shape other than a cut on the dashboard that was there when I bought the car. Its noticeable but not bad. The exterior is still completely stock as stated above. I spent all my money on mechanics then never got around to making it look good. The car has never been in a wreck to the best of my knowledge and it is in very decent shape compared to whats out there. The worst thing about it is the hood which is bent a little. The fenders and bumper have no damage so I don’t know what happened to the hood. Other than that, just typical little scratches and dings but nothing serious.
I love this car and I’m still not convinced I want to get rid of it. The things I don’t like about it anymore is the noise and the rid stiffness. Because I still love the car and don’t have to get rid of it, I will probably only sell it if the right deal comes along.
Im asking $6000 obo and the main trade I would be interested in is a Tacoma 4x4 ext. cab
or a Subaru wrx or 2.5 RS
If anyone is interested please feel free to make an offer.
PM me for pictures
Contact me via the number, maybe we can work something out http://www.hondamarketplace.com/show....php?t=2885151
http://www.hondamarketplace.com/show....php?t=2876414
Long shot from a taco but trade for my 1998 prelude?
Long shot from a taco but trade for my 1998 prelude?
Thread
Thread Starter
Forum
Replies
Last Post





