Sold!

 

looking to just sell the ls crank?

 

I would prefer to sell the block and crank together. Im giving it about a week. If not then I may be willing to part it out.

 

1. looks like a stock sleeved block
2. benson blocks actually have benson stamped out front. if it is sleeved, perhaps by another brand? please take closeup of the sleeves.

 

As i can't find the stamp on the block to prove its a benson product i took that down in the description until I receive further verification from the previous owner of the block who is a member on this site.
For further proof I will attempt to get a hold of a 81mm integra piston to show you that it will not work with this block. Only other thing I had to show proof was by using the measuring tape and the cylinder was quite larger that the 3.19inches that 81mm equals.


sorry about the quality of the pic but as you can see the sleeve is well past the stock 3.19inches and somewhere in between the 3.3-3.35inches that an 84mm-84.5mm cylinder is

 

Whether it's Benson's or not, you should know better. The 'witness' marks (sleeve separation between each cylinder wall) can clearly be seen in those pix and that shows that it is indeed a sleeved block. Stock-sleeve block do not have those witness marks (all 4 cylinder is one piece).

 

Thanks Mark! how have you been man, whats new?

 

My guess RS? Could be wrong.
But hell of a deal.
Free bump

 

I thought my RS sleeved block had a little RS marked on it somewhere. But just went to go look at it and couldn't really find it. My block is really dirty with oil and dirt everywhere so it might be covered.

Anyways bump

(lemme know if you want to part the ls crank later)

 

Thank you 209lsr_ly and Ricer no 7, I'll try to give it another look over see if I can find any unique marking but nothing seemed noticeable.
An ya i'll let you guys know if I part it out.

 

ttt

 

I don't think rs stamps there blocks cause I got a b16b and a b18c1 sleeved block by rs n there is no marking. As long as the sleeves can hold 32lbs of boost it doesn't matter who sleeved it.

Damn I can't believe it's not sold yet.
Ttt

 

food poisoning ftl bump

 

bump

 

ttt

 

bump
480 for block
80 for crankshaft

wont sell crankshaft before block

 

damn I just might make my roomate buy this. He wanted to do a full gsr swap but a might as well go lsv with a sleeved block this cheap.

 

wait is it 480 with the crank??

 

bump

 

480 WITHOUT the crankshaft, as you can see I'd rather keep it simple and everything together 20 bucks more you get everything.

 

how much can it be bored?

 

i'd assume based on looking at it and on what other sleeved b series blocks go up to somewhere between 86-88mm

 

I don't think you can bore more than 86mm safely. Cuz there a gasket sealing problem. correct me if i'm wrong.

Might be able to check out the block tonight. We you be available late at night. After 10pm ? I'll text u

 

SOLD !!!! to me. Just got back from stockton. Far drive. Bump good legit seller.

Thanks

Chris Luu

 

Thanks Chris! hope you guys enjoy the block, let me know when the build is done!