I have this 2000 usdm type r motor for sale or for trade plus cash.. Im looking for a stock 2000-2001 usdm type r or usdm GSR motor plus cash on top. Motor is built and a list will be shown at the bottom of what is done on the motor.. Located in Bakersfield Ca.

Motor has:
Skunk 2 head pack and valves
Ported head and Port matched intake manifold(stock type r manifold)
Buddy club cam gears
370cc injectors
Aem Pressure Regulator
70 Rpm throttle body
JDM Type R pistons
LSD Type R tranny with 4.7 Final drive
255 High pressure Walbro fuel pump
Profab header
stag 3 exedy clutch
8.8 pound ACT flywheel
S300 Tuned to the motor RED LINES AT 10,000 RPM with Harness :bang:
2.5 inch mandrel bend piping with JDM password test pipe and Spoon N1 exhaust
Spoon Spark plug wire
Spoon Kevlar wire cover
Spoon Oil Cap
Spoon Hoses
Spoon Thermostat
Spoon Fanswitch
Spoon Transmission Magnetic drain plugs tranny/oilpan
Mugen extended header studs
Mugen Steel Braided clutch line
AEM 3inch throwback cold air intake CARB legal

looking to get at least 5g's OBO for the whole swap. Looking to get 2500 OBO for a stock usdm gsr swap. Motor has to be 2000-2001. I know its impossible to get a us type r motor but it worth a try. Just looking to go back OEM. Thanks in advance. Just comparing to HMO prices and there motors are STOCK

 

glws

 

Thank bump

 

OBO

 

glws!

how much power this make?

 

ttt

 

Garbage

 

If i remember correctly over 230..

 

Your garbage with 71 posts. NOOOOOOB

 

ttt

 

fuuuuuu paperwork included?

 

yes sir

 

 

ttt

 

BUMP

 

thanks bump

 

ttt

 

ttt

 

thanks bump might just part out. not sure yet..

 

Part with the tranny? PM me

 

bump

 

Looking to get rid of the whole swap thanks