I've been doing some reading and wanted to know if I am correct...

If i take a d15b7 block, "plop" in a jdm d15b crank, then i can use any d16 oem or aftermarket rod or even a p75 ls rod with a p29 piston?

reason being...not spending 700+ on a custom rod to support good power in the b7 block. so 100 or so on a different crankshaft, 300 on some rods and 100 on some pistons seems more practical in my opinion. feedback greatly appreciated.

 

D15b crank = d16 sized rod bearings. Just built one last week.

 

Specifically it was a d15b with fj rods and vitara pistons.

 

sweet do you have any pics of the build that I could check out?