Percision 880's/ Walbro / H beams/ S300 boost sol/
Thread Starter
Honda-Tech Member
Joined: Mar 2006
Posts: 587
Likes: 0
From: Lima, oh, USA
Percision 880's/ Walbro / H beams/ S300 boost sol/
Changing up my setup got part with some stuff
- PTE precision 880cc injectors. need resistor box.. less then 3000k miles on them ---- SOLD
- Walbro 255 gss341 Fuel pump BNIB with strainer and install kit. ------ SOLD
- SCAT H beam B18a Rods brand new PN 5394 -- 300 shipped
-Weisco 81mm pistons USED for around 3000 miles will need rings (used on my other pistons) Best legit offer
- B18 LS Cleaned/checked/polished crank -- 150 shipped
- Got a add in Boost kit for the s300 has all the resistors instructions and 100psi boost solenoid thats never been installed. whole kit -- 80 shipped
Best way to contact is PM! If you give me a BS low offer ill ignore you and wont waste my time to reply to you. prices on semi firm there is A Small bit of wiggle room but not much.
- PTE precision 880cc injectors. need resistor box.. less then 3000k miles on them ---- SOLD
- Walbro 255 gss341 Fuel pump BNIB with strainer and install kit. ------ SOLD
- SCAT H beam B18a Rods brand new PN 5394 -- 300 shipped
-Weisco 81mm pistons USED for around 3000 miles will need rings (used on my other pistons) Best legit offer
- B18 LS Cleaned/checked/polished crank -- 150 shipped
- Got a add in Boost kit for the s300 has all the resistors instructions and 100psi boost solenoid thats never been installed. whole kit -- 80 shipped
Best way to contact is PM! If you give me a BS low offer ill ignore you and wont waste my time to reply to you. prices on semi firm there is A Small bit of wiggle room but not much.
Last edited by Hondaruss; Nov 6, 2010 at 05:09 PM.
Thread
Thread Starter
Forum
Replies
Last Post
JDM EJ1 95
Classifieds: Forced Induction
9
Aug 12, 2013 10:58 AM
Obama
Classifieds: Forced Induction
21
Jul 16, 2010 09:01 AM