^So this ******* of a DPI motor decided to Jump timing and smack some valves. Wouldn't start..backfired...yea. EASY fix but I'm not that kinda guy..I don't FIX singles I replace them..



^Long story short, the selfish bastard of a motor was taken out with extreme prejudice...[Elapsed time: 45 minutes]


^Another angle..


So at this point a few of my boys go..."Dude...clean the bay...." So Me..I don't give a cap about bays. I don't build show cars I build cars for GO..but I entertain it.

So..with Brake Cleaner, Wire Wheel, Soap, Water, Rag...we went in..


^Before..



^After

Let's get some more "After" goin..







So then they say..."DUDE...Clean the motor a lil bit..." So I said BUMP it...c'mon..



^Looks alot better then it did before..

NEXT set of pics will show the motor dropped in and snugged..coming soon..


Stay tuned...I'm TURBO'n dis bitch next.

ALSO...I figued i'd share some of my Cars with ya, some may know, some may not but I own a few civics..


^^Fully built LS-V Turbo..



^^All Motor Built H22



FRONT most car, Semi-Built B20-Vtec.

More comin soon...Taking my HF to some new heights, havent decided to go Turbo or Supercharged LS yet..

 

^^Motors finally in, took two seconds ad it's a decent fit, Mounts have it kind of lopsided though, it's about an inch lower on one side, Dunno if i'ma let that rock, I may go with the innovatives over the hasports as it sat evenly in my other hatch. I know i'm definitely going to either wire brush and polish the head of paint it black or red, I may go with black metallic paint for a kind of a audi-finish to it, I'd prefer to ONLY see a red valve cover on a vtec head. Plus it'll compliment the black widow theme I'm going to begin on the car once I finish draping the interior in obsidian leather I picked up today from the fabric store...i MAY do a DIY on wrapping seats..and a Picture based DIY on Dpi-to-MPFI granted I have the patience.



Good to go...

Now i'ma wire dis bitch up and get it started...

 

What DOHC motor is that?

 

he said he's going ls/t, and going off the valve cover i'd say b18b1