2001 Phoenix Yellow Integra Type R
149,xxx miles
Number 332
I got the car in October 2008… It was located about 40 miles outside of Atlanta and took almost 13 hours to get there because of road construction in every single state on the way down there...
I left Friday right after work and went to pick up my girlfriend that lives down at IU. We drove until we got into Georgia and stopped at a jenk *** Motel 6 and slept for four hours, then continued our drive to Atlanta. After test driving and inspecting the car for 2 hours, purchased the vehicle and drove to a local Burger King to eat breakfast and tape the car up for the trip home. We drove about half way back and decided to stay in downtown Nashville for the rest of the weekend.

Mods when I got it:
~Ingen Cold Air Intake
~Dc Header
~Custom Vibrant Catback
~Drilled/slotted front rotors and new pads all the way around
~AEM Under Drive Pulleys
~Skunk2 Short Throw Shifter
~HIDs
The owner had just had a lot of maintenance done
Timing belt, Water pump, Tune up, etc….

The day I got it:















Me taping it up for the trip home:










Pics on the way home:














Page one summer 2009
(Working on Suspension and Brakes, as well as getting ready for IA 2009)

 

More to come

 

Looks good cutie

 

Can't get enough PY ITRs. In for more

 

nice pants

 

this should be a nice build, subscribing.

 

please tell me thats your gf. cause if thats a guy that statement was so gay

 

In for this

 

yes its his gf look @ the avatar pic i can tell its a female behind his car UNLESS its a *******?

 

haha yeah, that is my girlfriend

 

sweet build thread

 

FRESH!

 

In for this, should be good!

 

DANGGG JDM MOOOOOGEEEENNNN RRRRR

 

i remember seeing this on the marketplace i think! good find!

 

Winter 2008




Summer 2009

Took off, cleaned, sanded, and etching primer, then painted, then cleared.
Front spindles
Front shock forks
Front control arms
Rear control arms
Rear trailing arms (spindles)









After i painted then i put new bushing in control arms, and also replaced Every bushing on the car


I also re-under coated the wheel wells




Then put new front and rear hub bearings, and while i was doing that I installed a set of skunk2 extended lug studs.

Put on some more parts
D2 coil overs on
Skunk 2 PRO series adj. front upper control arms
Russell stainless steel brake lines
Skunk2 PRO series adj. rear upper control arms
SPC rear toe arm

 

good start

 

thanks man

 

love for the ITR !!!

 

nice itr.

 

In for moar!

 

pics from Indiana University Bloomington

 

Lookin good bro!!!