Hey guys...I'm in the middle of doing a motor swap on my 1990 Civic hatch. I'm going with a JDM B16A OBD-0 Engine and currently have a Y1 LSD transmission. It came with an SK7 Intermediate shaft, which still had the end of the CV axle attatched. I have taken out CV axles before, and have tried numerous ways but this one just isn't budging. At this point, I'm stressed and looking for a solution because I'm afraid the bushing in my SK7 may be damaged. Is there any where else I can buy a new or used SK7 or SH3 intermediate shaft?? If not, is there any other Intermediate shaft that can be used on my car, and if so, what axles would I use with it? Any help would be appreciated.

 

Try the 90-91 integra

 

USDM spec? And would I use the same axles?

 

found what i'm looking for. Thanks