CA FS: 97 JDM GSR
Thread Starter
Honda-Tech Member
Joined: Mar 2006
Posts: 558
Likes: 0
From: NORCAL
FS: 97 JDM GSR
1997 RS Integra
Clean Title
13x,xxx miles on body swapped od. reads 24x,xxx
Registration is currently expired (smog required)
Exterior:
Non-HID JDM front
16in Slips
215/45 RT-615 Azenis 20%
GC coil-overs
Replica Mugen front bumper
Apexi muffler w/ professionally made 2.5” mandrel bent exhaust
Engine:
Was rebuilt (early 08 Sept) only has about 2500 miles on it The last time I drove the car was in January 09
GSR block with golden eagle sleeves 84mm
ARP head studs
Cometic 3-layer head gasket
GSR head port polish and 5 angle by port flow design stamped #2292
GSR transmission approx 85k mi no grinds
9lbs ACT flywheel
New valve train installed by port flow along with oversized valves
CTR intake cam
GSR exhaust cam
Toda timing belt
JE pistons 10.3:1 or 10.7:1 can't remember and invoice doesn't mention dome cc's
Eagle Rods
New oil pump, water pump
ACL Mains and thrust washers
Honda Rod Bearings
Hondata intake manifold gasket
Skunk2 intake manifold Comes with carb sticker
ARC Intake elbow
Rage tri-y anti-reversion header (dented on bottom thanks to alta sierra body shop)
Currently the car isn’t running because the battery is dead. It's running on an obd1 p72 with a conversion harness. No cels. I was planning on running a turbo, but i decided I wanna get outa hondas for right now. It was dyno tuned by Six Sigma in Stockton before they moved. The motor made 193whp. The body is good aside from the drivers side rear bumper and the filler panel/valence. I backed into a trailer scratched the top of the bumper right by the tail light and dented the bumper filler panel, I replaced that but the paint doesn’t match. It’s dark purple now. The front and the roof need new paint. Selling because I'm getting away from honda's and looking to pick up a street bike.
PRICE DROP!!!!!!! -3500$$OBO
EMAIL ME @ mchubbuck@gmail.com
PICS BELOW AND AT BOTTOM OF PAGE.
Clean Title
13x,xxx miles on body swapped od. reads 24x,xxx
Registration is currently expired (smog required)
Exterior:
Non-HID JDM front
16in Slips
215/45 RT-615 Azenis 20%
GC coil-overs
Replica Mugen front bumper
Apexi muffler w/ professionally made 2.5” mandrel bent exhaust
Engine:
Was rebuilt (early 08 Sept) only has about 2500 miles on it The last time I drove the car was in January 09
GSR block with golden eagle sleeves 84mm
ARP head studs
Cometic 3-layer head gasket
GSR head port polish and 5 angle by port flow design stamped #2292
GSR transmission approx 85k mi no grinds
9lbs ACT flywheel
New valve train installed by port flow along with oversized valves
CTR intake cam
GSR exhaust cam
Toda timing belt
JE pistons 10.3:1 or 10.7:1 can't remember and invoice doesn't mention dome cc's
Eagle Rods
New oil pump, water pump
ACL Mains and thrust washers
Honda Rod Bearings
Hondata intake manifold gasket
Skunk2 intake manifold Comes with carb sticker
ARC Intake elbow
Rage tri-y anti-reversion header (dented on bottom thanks to alta sierra body shop)
Currently the car isn’t running because the battery is dead. It's running on an obd1 p72 with a conversion harness. No cels. I was planning on running a turbo, but i decided I wanna get outa hondas for right now. It was dyno tuned by Six Sigma in Stockton before they moved. The motor made 193whp. The body is good aside from the drivers side rear bumper and the filler panel/valence. I backed into a trailer scratched the top of the bumper right by the tail light and dented the bumper filler panel, I replaced that but the paint doesn’t match. It’s dark purple now. The front and the roof need new paint. Selling because I'm getting away from honda's and looking to pick up a street bike.
PRICE DROP!!!!!!! -3500$$OBO
EMAIL ME @ mchubbuck@gmail.com
PICS BELOW AND AT BOTTOM OF PAGE.
Last edited by michael_c; Jul 10, 2010 at 03:00 PM. Reason: changed email address
![Black-Ty [EG6]'s Avatar](https://honda-tech.com/forums/customavatars/avatar999547556_3.gif){kind=avatar}
Thread Starter
Honda-Tech Member
Joined: Mar 2006
Posts: 558
Likes: 0
From: NORCAL
Re: FS: 97 JDM GSR
im outa town right now in la ill be home at the end of this week and get some pics up...
black on goat-ish brown
rear seats and trunk area carpet removed
black on goat-ish brown
rear seats and trunk area carpet removed
Last edited by michael_c; Mar 3, 2010 at 09:30 PM.
Trending Topics
Honda-Tech Member
Joined: May 2009
Posts: 818
Likes: 0
From: Stockton, CA
Thread Starter
Honda-Tech Member
Joined: Mar 2006
Posts: 558
Likes: 0
From: NORCAL
Honda-Tech Member
Joined: Jan 2005
Posts: 172
Likes: 0
From: northern, Ca, usa
Re: FS: 97 JDM GSR
I think it looks better hardware black then whatever color it came. Its crazy people post dumb crap to try to be funny in an internet forum. It likes 95??!!98 does that from his/her history.
Thread Starter
Honda-Tech Member
Joined: Mar 2006
Posts: 558
Likes: 0
From: NORCAL
Re: FS: 97 JDM GSR
i'm not planning on parting it. i'm lookin to get the garage totally empty, then start over.......lol
