hey theres 4 wires, red orange brown and black that connect the s200 module to the ecu. well on the s200 side i guess im missing the conector that plugs into the unit. can anyone tell me which wire goes to what pin, i believe it connects to J1, not sure but J1 had 4 pins, j2 is 2 pins for 2 step and j3 is ?no clue, being unused? can anyone clarify this for me, thanks in advance im noob to all this

 

http://www.hondata.com/downloads/s20...n%20manual.doc

 

jus read the manual only thing i got out of it was

Route the ECU to interface box cable out either under the lid or through near where the connectors exit the ECU case. In both cases make sure that there is no chance of the cable being pinched or chaffed where it passed out of the ECU. A slot may need to be filed so that there is room of the cable to pass out of the ECU. Make sure the edges are not sharp. A rubber gromit make help.
Connecting the 4 wire lead
Simply plug in the connector, this will only plug in one way.

doesnt really help out anyone else have anything?

 

bump?helppp

 

blleeppp

 

yea i know right?

 

i really dont want to spend the money on new cable, does anyone have one they can just look at for me?