Recently acquired a password jdm intake and from all the pictures i have seen there was only 1 port on the pipe that goes to the valvecover. This one seems to have 2 but one is covered.




Is there a way to swap the plug and the port? Is this normal?

 

the other 1 is for the iat sensor
if u dont have 1 just plug it up

 

Is it possible to switch them around as it looks really ugly with the plug up top. I would rather reverse them? How do you remove the plug without breaking the grommets. also my plug was already filled with a plastic peice that comes with the kit. How do i remove it? my car has the iat on the intake pipe aswell? any comments on how to do this?

 

what i meant was how can i remove the cap above the breatther. it seems to be a little peice of plastic that pushes in to flare the rubber.