Just finished lining up and ordering the rest of my stuff to get my d16y8 to b16a3 swap running.

What should i do next is my question to you guys. I want to learn more about cars and etc. So this is my book.

So far i have
-Cold air Intake, i made this my self, was inexpensive. Its only temporary.
-Skunk2 MegapowerR Catty back exhaust

And this swap gave me some problems getting it in. So im looking for ideas up in the top end of my motor. I dont want to pull it out quite yet to do the bottom half.

Any suggestions?

 

headers, light weight rims.

 

could do plugs and wires and if you want to take on some bigger mods you can go for cams, cam gears, intake manifold, valve springs, port and polish

 

you could do a lot more but its all about how much money you have. trust me you can drop $10k and still not happy. just basic mods will do fine unless your planning on a racing.