Doing a rebuild on ye-olde D15B2. Can't figure out where these two go.
Posting on houston-imports resulted in even more confusion.




And here is what I managed in about.. 5 minutes. X-treme Anodized Blue and Gold. Enjoy hatin'




[/QUOTE]

 

said gasket is either water pump gasket or oil pump gasket

 

bottom left: o-ring cam holder?

#17
http://www.hondaautomotiveparts.com/...=CYLINDER+HEAD

 

That's correct, it's the special double O-ring that goes beneath the rocker shaft assembly around the #3 cylinder spark plug tube. The other cylinders use a normal single O-ring.

The gasket at top center is a throttle body gasket for a DPFI manifold. It goes in between the throttle body itself and the insulator plate on the manifold.

 

Ok, well that one is not getting changed - I'm leaving the head alone for this one.

 

the other one looks like a cam sensor o-ring like the ones found on 3rd gen prelude and the zc dohc motors i beleave

 

lol "Never Drift", I didn't think FWD's can drift, unless you have McDonalds trays under the rear wheels.

 

mine was drifting friday night but a little bit of alcohol was involved