ATS B-series ITR transmission SOLD
Gearspeed / Synchrotech B16/GSR/ITR 3-4-5 Carbon/Moly coated synchros - SOLD
Acura Amber Radio - SOLD

RS Machines 82.0mm PR3 (B16) Pistons - $170 shipped - Roughly low 11:1 with a 87.2mm crank and b16/itr head, ~11.5:1 with GSR head with 87.2mm crank. Comes with new rings, wrist pins, and a moly coating on the skirts. These are 180+shipping from RS Machines (ebay).





ITR Rods - $180 shipped 30k miles on them. Mint condition, were replaced with forged stuff for a boosted setup. Stronger than GSR rods, lighter than Eagle rods -- great for an all motor setup or mild boost.






Civic Si Brake Booster - $80 shipped


Civic Si 4 wheel disc proportioning valve - $50 shipped


AEM 2.5” short ram tube- $50 shipped - Bracket is cut off. No filter. Couple scratches.



DC/EG 19mm rear sway bar - $50 + shipping, or 75 shipped, whichever ends up cheaper - I believe its a suspension techniques, but don't quote me. Comes w/ the bushings for the subframe, but no end links.



Phillips D2R HID bulbs - $50 shipped, will not sell just one unless you find someone to take the other.




Honda centercaps $35 shipped – Rota ARE SOLD. – Hcaps are P/N 44732-S0X-A00


http://img.photobucket.com/albums/v3...e/P1000862.jpg

Compustar Alarm w/ Remote - $50 shipped – Just the remote and the brain.



OBD2a (97)LS intake manifold w/ AIT & IACV(not in pic, will include) - $ 40 + shipping

http://img.photobucket.com/albums/v3...e/P1000837.jpg

OBD2a (97)LS Water Neck (back of the block)- $15 shipped

http://img.photobucket.com/albums/v3...e/P1000849.jpg

OBD2a (97)LS Thermostat housing - $40 shipped - thermostat, coolant sensor included

http://img.photobucket.com/albums/v3...e/P1000846.jpg
http://img.photobucket.com/albums/v3...e/P1000847.jpg

OBD2a (97)LS timing belt cover - $20 shipped

http://img.photobucket.com/albums/v3...e/P1000859.jpg

LS alternator belt - $ 10 shipped - good condition, about 15k miles

http://smg.photobucket.com/albums/v3...t=P1000851.jpg

3” Exhaust 3 bolt flange- $15 shipped – I cut it off so I could run an exhaust clamp. Its off a Lovefab 3” exhaust.

http://img.photobucket.com/albums/v3...e/P1000865.jpg

90 Degree mandrel bend intercooler pipe 2.5” - $25 shipped - bead welds on the ends for sealing. Mild steel, 2.5”.

http://img.photobucket.com/albums/v3...e/P1000867.jpg

Stock EG Hatch DX Upper Control Arms Make Offer
http://img.photobucket.com/albums/v3...e/P1000616.jpg

 

^

 

bump

 

ty bump

 

^^^^^^^^^

 

^

 

^

 

trans sold

 

^

 

TTT for a cool dude