What is the best way to paint the shift **** (6spd) numbers red?
Thanks

 

I would try a very fine tip brush with some model enamel paint. Or, if you have a fine tip Sharpie, that might work just as well.

 

there is a trick you can do with a red crayon that works perfectly for this, I bet if you search for it a bit you should find exactly how to do it

 

I guess it depends on the ****, lets say it's a metal ****, you could probably just paint the whole top of it, then sand it with a flat black to get rid of everything except whats in the indented numbers, then use a higer grit to get it back to a brushed metal look.

 

i used a toothpick and testors model paint. then just wiped over the top of the **** with a paper towel and laquer thinner to clean any excess. leaving the paint only in the numbers.

 

melt the crayon on it, and wipe off before it dries...

 

that's what I've heard to do as well....

 

i used red nail polish haha

 

Crayon is the best way.

 

i just used model paint and painted the whole top and wiped it off. the numbers stayed painted

 

dont use crayons, it melts on a hot day, not a good idea. my brother did it.

 

hey friend i also dont have much idea about it...can anyone solve this problem or answer this question?

 

this is what i would do. use a fine tip brush and some paint. just take your time. be careful, and keep a rag or paper towel on hand to wipe off any extra. i also wouldn't go with the crayon because like stated above if it gets hot enough its going to melt again.

 

i used wax and poured it in, then whiped off the rest,