TX 90 crx si shell
I have decided to sell my crx and it has a clean tx title, with no rust on it. im asking $1100
the good:
Jdm front end conversion.
battery relocated to the trunk
7.5" touch screen molded into the dash( i had a carputer in it)
jdm black center console
wired for 99-00 si cluster(not included)
wired for 2 amps, and all the interior speakers wire ran to amp.
new pads and cross drilled rotors, brake booster, front braided brake lines put in 3 months ago
new inner and outer tie rods put in 3 months ago
full interior
2.5" exaust with a flowmaster 80 series in the back so singe in dual out
new front floor mats
fiberglass hood with locking hood pins
inovative crossmeber, with the bars powder coated black, just not installed
the bad:
shitty paint job done a year and half ago has orange peal bad
the side skirts were screwed on by normal crews and u can see them
sunroof doesnt work and no interior head liner
new carpet, but i didnt have a heat gun to get the back to lay down right





the good:
Jdm front end conversion.
battery relocated to the trunk
7.5" touch screen molded into the dash( i had a carputer in it)
jdm black center console
wired for 99-00 si cluster(not included)
wired for 2 amps, and all the interior speakers wire ran to amp.
new pads and cross drilled rotors, brake booster, front braided brake lines put in 3 months ago
new inner and outer tie rods put in 3 months ago
full interior
2.5" exaust with a flowmaster 80 series in the back so singe in dual out
new front floor mats
fiberglass hood with locking hood pins
inovative crossmeber, with the bars powder coated black, just not installed
the bad:
shitty paint job done a year and half ago has orange peal bad
the side skirts were screwed on by normal crews and u can see them
sunroof doesnt work and no interior head liner
new carpet, but i didnt have a heat gun to get the back to lay down right





Last edited by 91crx_xsi; Jun 28, 2010 at 01:54 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
z crx z vtec z
Vehicles for sale
2
Feb 4, 2008 09:52 PM







