I saw a post on Honda-Tech a couple of weeks ago for a introductory $30 cleaning service by Mike Palm. I sent out three sets of 450cc DSM injectors for cleaning. Not only did Mike clean the injectors he also replaced the rubber o-rings and pintle caps. Plus he wrote down the flow rating of each injector. Great service! If you need some injectors serviced you can email him at: TurborexR@aol.com


Before:


After:





Flow rating:
1A = 452cc
2A = 450cc
3A = 450cc
4A = 450cc

1B = 448cc
2B = 448cc
3B = 448cc
4B = 448cc

1C = 448cc
2C = 450cc
3C = 448cc
4C = 450cc

 

what was the turnaround time like? might be a while before i install my stuff so might as well

 

About a week for this set.

 

I will be getting Mike to clean a set of DSMs in a few weeks

 

Mike cleaned a set of 450cc for me too...

GREAT SERVICE!!!!!!

I seriously can't recommend him enough...I'm so used to lazy asses and ******.

Suprdave

 

... i just got my set back from mike as well... excellent service!!!

thanks

 

send mine off to him last week, good to hear that he does great work!

 

so what does he charge now?

 

just got a reply from him via email...he said he's not going to be cleaning injectors til sometime in december . if anything try emailing him...

 

Back from the dead... is Mike cleaning injectors again yet?

 

Here is the last time he did it zeus:
https://honda-tech.com/zerothread?id=346574

But to answer your question, no. Well, not at this time anyway.

art

 

mike does great work
can't recommend him enough