Yea yea, its ebay I know. I have no money and its better than stock, friend had one so I was able to look at one up close before getting one.

Anyhow, measuring the outlet of the header is shown below and I have a couple questions (not a noob so don't dumb sh*t down, please)...



1) What all is the process for connecting it to the exhaust. Header --> Donut Gasket --> 2.5" Flange (just a regular flange)?





2) The outlet is a little under 2.5", would the right size donut gasket be 2.5"? (Anyone know some places with good prices?)

3) I have a slightly used 2.5" cat with no flanges, just wondering if there is a specific type of flange to connect to the end of this header.

 

You will need a 2.5 in doughnut gasket. Some exhaust shops have them. I believe the s2000 also has a 2.5in gasket. Also you would need a 2.5in 2 bolt flange to fit the doughnut.

Follow this link and you can get both for like 34 dollars. http://twincamtech.stores.yahoo.net/25incolflan.html

Here is a picture of the flange.

 

Thank you so much.

Didnt go with inlinefour. $59 shipped for flange and gasket????? Crazy, I just ordered mine seperately other places for under $40, woohoo.

Thanks again.