Motec Gear Detection.
Thread Starter
Honda-Tech Member
Joined: Oct 2005
Posts: 2,501
Likes: 2
From: expensive land, usa
Motec Gear Detection.
Have not gotten a response on the Motec Forums.
"I have my VSS(digital signal) to DIG 1input and selected as Speed Measure.
I have Gear Sensor Source set to Dig 1.
I have all the correct gear ratios, final drive(via factory specs), teeth count and calibrations set, and matchs my speedo on the dash +/-1 mph.
When looking at the sensor view(V) It reads "speed", but does not display which gear I am currently in. It reads 0 as my gear selected.
Is this only available through advanced functions?"
"I have my VSS(digital signal) to DIG 1input and selected as Speed Measure.
I have Gear Sensor Source set to Dig 1.
I have all the correct gear ratios, final drive(via factory specs), teeth count and calibrations set, and matchs my speedo on the dash +/-1 mph.
When looking at the sensor view(V) It reads "speed", but does not display which gear I am currently in. It reads 0 as my gear selected.
Is this only available through advanced functions?"
Thread
Thread Starter
Forum
Replies
Last Post
