Item Description: Honda Garage Sale

Location: Grand Haven, MI

Price: n/a
-------------
I will continue to edit this first post with all available items for sale from my previous boosted D project. I'll take decent offers on any of the below items.

At this point I'd like to sell it as a long block assembled setup. But if I can get buyers for the bottom end and the head seperate I'll part it out. Motor has about just under 7K miles on it. Only ran with a greddy kit and a little TD05. This motor needs much more! I have some shots of the port job if interested as well.

Not my car but exactly what it sounds like with this monster--
http://videos.streetfire.net/video/I...-in_147133.htm


*** Note Turbo/manifold and trans are not included ***

Asking 1600.
Located in West Michigan area

D16Y8 Head, with competition street port performed by Stewart Engines -- http://www.stewartengines.com/headwork.html
Complete Crower Valvetrain
Crower Stage 2 Turbo Cam
EdelbrockPerformer X Manifold with all sensors and unknown TB.
Skunk2 Adj. Cam Gear
MSD 8.5 Plug Wires







D16Y8 Block
ARP HEAD Studs
ARP Rod Bolt
Eagle H Beam Rods
Weisco Coated 9:1 Compression Pistons
Knife edged and balanced crank.
Motor was balanced and assembled by Stewart Engines.

 

Damn... nice set up. I wish you were closer to me!!

 

Thanks! If someone likes road trips I'm more than happy to meet them half way.

 

bump

 

pm send

 

PM sent back.

 

hump bump

Thanks for the interest keep them coming! This needs a new owner to boost to the moon!

 

Bump

 

where are you located i am interested in the bottom end

 

Located in Grand Haven, MI Sorry for the delay I have been out of town.

 

if it is not sleeved then it is not fully built

 

G Thanks!

Bump

 

how much for rotating assembley bottom end shipped or meet half way zip 37079

 

Sorry I think I just realized you want the crank, rods, and pistons correct?

Why not just take the nice block with it! I'll get you a price.

 

What are you asking for the long block?

 

1,600.00

 

if dacuslil want the block i want the head. shipped to 32086 lmk thanks im located in florida pm me thanks again

 

willing to sell me all of it other then the performer x manifold? lmk cash in hand if we can work something out

 

PM'd you.

Also added some shots of the head.

 

Similar setups have easily shown 400+ BHP tuned properly. Some act soon, else it goes under the knife to be sold as bits and pieces.

 

Damn... I really wish I had the $$$. You are 11 hours (one way) from me and I would drive it if I had that kind of money laying around.

Bump!

 

Thanks man! Yeah it's looking more and more like a possible part out or just put it on the side and hold it.

 

Interested in the Cam and cam gear possibly the plug wires too pm me with a price if you decide to part out bump

 

If it goes that wrote keep a eye on this thread, as it'll change over to parts and prices if I do end up tearing it down.