Hey All,
I have a gen 1 B16A engine in my DA...I had problems starting my car, like it would not crank over, so I reset my ECU. After i reset my ECU, my car started very hard, would pop out of the exhaust, and run like it was misfiring. I replaced the spark plugs, and then did a test on the wires to see which one or ones were missing. I am getting a spark out of the leads of the wires, but cylinders 1 and 3 are not firing, even with a spark. What do you guys think it is? Fuel Injectors?

The cap, rotor, and wires were replaced a few months ago and like I said i just replaced the wires. In a few days when the weather is nice I am going to take off the fuel injectors to take a look at them. I just find it very odd that right after I reset my ECU cylinders 1 and 3 are not firing.

Any ideas would be much appreciated...

--Dan

 

bump for help