can i use the stock rsx axles and halfshaft for my kseries in my dc2 if i have the itr 36mm hubs..

 

I think so but I'm no k series expert, I have 36mm knuckels for sale if you need them.

 

what size are the itr 5 lug hubs 36mm? what size are the rsx outter axle where the nut goes ?

 

hasport mounts + a K series engine + 36mm hubs (JDM ITR or US Crv) = will accept rsx axles no problem at all, trust me i know because i run that setup and i have never had any problems. lol and i dont drive me caR nice either so the lengths of the axles are perfect

 

ok so i need jdm itr hubs and the rsx axles and halfshaft will work fine correct ?

 

Yep, thats my setup!

 

ok thanks guys..

 

You need to run the RSX-S axles for the JDM 36mm hubs. The base RSX is 32mm and will work for the USDM ITR. But yes, they will all be the right length. Just make sure you have the right set for your hubs

 

what about base 32mm rsx axles and stock gsr 4x100 hubs will that work ?

 

no they will not, i think the non itr us hub spline is 28 and the USDM itr is 32mm?

 

WRONG, both 32mm.

 

thanks for the correction

 

It's nice to see a thread where something is accomplished.

Any one ever tried the base rsx 32mm axles with the usdm 4 lug 32mm set up?

 

thats what i wanna know