hey guys i was told by a mechanic that the source of a rattling noise while accelerating especially when the car is cold is due to my intermediate drive shaft bearings being bad. I have to replace my driver side axle as well so i plan to do them both in one shot. The bearings are $40 at honda and i was just wondering if there were any writeups for the replacement of them or at least what tools will be needed and what to expect. I have only one day to do this since it is my DD and dont want to get stuck after i have the axle out.

95 lx 5spd

 

bump

 

come on guys, you mean to tell me that no one has done this before?

 

Your better off replacing the whole shaft. If there are any marks in the race for the bearing on the shaft assy it will take out the new bearing pretty quick.