FS: DA6 parts JDM bumper support, cover, eneos, ITR head
Thread Starter
Honda-Tech Member
Joined: Jul 2004
Posts: 1,943
Likes: 0
From: 909, ca, usa
FS: DA6 parts JDM bumper support, cover, eneos, ITR head
For all parts listed, please contact me at bnharmony117@Yahoo.com
I have a 92-93 JDM front bumper support, will fit 90-91 integras with 92-93 bumper mounts. very good condition, no major rust - $60
I have a milano red 92-93 JDM rear bumper cover w/ USDM bumper support. slightly faded on top portion, but not extremely noticeable if buffed and waxed down. SUPER clean, no noticeable damage. Foam inserts included as well. ready to bolt on! WILL NOT PART OUT THE COVER FROM THE SUPPORT - $75
NOTE: there is no difference between a USDM and JDM bumper cover, I list it as JDM only because it indeed came off a JDM XSi, and replaced lightweight bumper support with my own.
other parts for sale
E_Neos 0-20 wt. 6 qts (1 case). $45 for all. and YES! this is what i used in my motor when I dynoed 236 and 228 hp to the hubs at CAT, along with 26 MPG
this is a smokin deal!!! ebay prices in comparison!
http://cgi.ebay.com/ebaymotors/ENEOS...ehicleQ5fParts
( if no interest before new years, they are going in the trash!)
door panel $10
passenger side bumper light $10
blown ITR cylinder head AS IS what is pictured is what is included! $25 ( if no interest, I'm taking it to the recycling center!)
I have a 92-93 JDM front bumper support, will fit 90-91 integras with 92-93 bumper mounts. very good condition, no major rust - $60
I have a milano red 92-93 JDM rear bumper cover w/ USDM bumper support. slightly faded on top portion, but not extremely noticeable if buffed and waxed down. SUPER clean, no noticeable damage. Foam inserts included as well. ready to bolt on! WILL NOT PART OUT THE COVER FROM THE SUPPORT - $75
NOTE: there is no difference between a USDM and JDM bumper cover, I list it as JDM only because it indeed came off a JDM XSi, and replaced lightweight bumper support with my own.
other parts for sale
E_Neos 0-20 wt. 6 qts (1 case). $45 for all. and YES! this is what i used in my motor when I dynoed 236 and 228 hp to the hubs at CAT, along with 26 MPG
this is a smokin deal!!! ebay prices in comparison!
http://cgi.ebay.com/ebaymotors/ENEOS...ehicleQ5fParts
( if no interest before new years, they are going in the trash!)
door panel $10
passenger side bumper light $10
blown ITR cylinder head AS IS what is pictured is what is included! $25 ( if no interest, I'm taking it to the recycling center!)
Thread
Thread Starter
Forum
Replies
Last Post
doublethink
Honda CRX / EF Civic (1988 - 1991)
2
Jun 30, 2008 08:08 PM
