I have a 1990 Honda Accord Sedan F22A4. It was a junker but its not in bad condition, needs a new exhaust, plugs, wires, and dist cap. So ive already bough an MSD Dist Cap, NGK 7.5mm Plug Wires, and NGK V-Power (.044") Plugs. I cannot figure out the plug configuration for the cap and plug wires. My friend pulled them out before i could mark them.

Heres the information on the car:

1HGCB7560LA146315
1990 Honda Accord EX
Sedan 4DR
2.2L L4 PFI SOHC 16V

 

With the distributor cap installed, start at the bottom right with number 1 and move clockwise around with these following-3,4,2.

 

thanks

 

wheres the bottom right?

can you label this and post it here or something

http://good-times.webshots.com...COlPv

^ thats a pic of the distributor which one is bottom right?