I bought a junk F22b1 and am slowly building it up. I cant seem to find anywhere that lists the F22B1 as an application.

Has anyone done internals? What brands and where did you get em?

 

You can get JE to make them custom.

 

I know there is a site/place that carries everything for the f22 motor. A local friend of mine was telling me about it, ill see him tomorrow and get the site name for ya.

 

I think JE makes them, they dont need to be custom made, i have a catlogue with them in it.

 

http://www.raceeng.com/

Ask for Ron.

 

Race Engineering makes pistons for the F22. Wiseco makes the pistons for Race Engineering, by the way. Also, Crower makes rods for the F22.

 

yeah ask for Alen at race enginering. they are top notch. i got my stuff from him.. good guy

 

wiseco can make them.. I'm gettting it for 420 shipped or so

 

he-he, he said 420 dood

 

They dont list the app on their site. They have the H23 but dont know that they are the same.

 

CR-B93747B.......That is the Crower part number on Race Engineerings site. The B20, F22 and H23 all use the same rod. I believe they are $660 retail. I can proabably get them cheaper for you. Also, I believe the F series motors are like H series motors in that you must have them resleeved when you install new pistons. This is because these motors dont have ductile iron sleeves from the factory. Check me on this though.


[Modified by EvoAccord, 3:58 PM 7/17/2002]

 

420, I don't get it. j/k

 

hehehe

420

ya they need to be resleeved .. no ductile iron on the block

 

i love 420...thats bc everyday is 420...haha

 

I got all my internals from a company called race engineering. However I didn't have to resleeve my block when I put the new pistons in.

JE pistons 8.5:1
crower rods
SS Valves
and a bunch of other junk

http://www.cdmotorsports.com/elvis.htm


[Modified by NXAccordTO4B, 8:07 PM 7/17/2002]

 

hahah all you freakin pot heads

 

I can see an echo..

 

True to a point, you need (read: SHOULD DAMN WELL GET) sleeves if you overbore. You don't need sleeves if you just change the pistons, unless you're going to some crazy compression ratio.

 

Talk to rocket in the FI forum, he's putting a gb together on ross pistons.