dc2 carbon kevlar (RARE!!!!!!!!!!!!!)
Thread Starter
Honda-Tech Member
iTrader: (2)
Joined: Jun 2007
Posts: 3,648
Likes: 0
From: pocatello, idaho, u.s.a.
as of now i know of very few people using carbon kevlar for their hoods. well not only is this a carbon kevlar hood for the dc2, but this is a specially made hood for my car. this hood was made by composites fab just as some of the others. where-as i did most of the work for dustin and got paid little when i did. i figured that a fatty hood was in perfect order when the shop shut down. when dustin shut the shop down, i made him let me make one last hood for my car. as some of you probably know, in a fab shop time for your own car is scarce. i utilized the this time to the fullest and wrecked my car the day before i finished the hood and its been sitting in my garage ever since.now need some money and i dont have a car for this hood so. lucky someone out there.
FRAME COSTRUCTION: firstly the frame was made from carbon rather that woven fiberglass. all latchpoints, front and rear; had an extra layer of the kevlar.that brings that latchpoints to two layers of carbon and two layers of kevlar. good luck breaking that!
SKIN CONSTRUCTION: the skin to any hood is pretty straight forward. all this one has is an extra layer of the woven fiberglass to increase rigidity.
LATCH CONSTRUCTION: made of high grade stainless steal and welded to perfection by one of our metal shops out here. backing plate is 1/4 inch and the latch bar is 1/4 inch in diameter.
will ship any here in the U.S. and i will post some pics when i get some more time. ive been real busy lately and ill try to check this page as much as possible. my e-mail is dopecivic94@yahoo.com
not too attached to any kind of payment. will trade, sell, what ever. lmk.
FRAME COSTRUCTION: firstly the frame was made from carbon rather that woven fiberglass. all latchpoints, front and rear; had an extra layer of the kevlar.that brings that latchpoints to two layers of carbon and two layers of kevlar. good luck breaking that!
SKIN CONSTRUCTION: the skin to any hood is pretty straight forward. all this one has is an extra layer of the woven fiberglass to increase rigidity.
LATCH CONSTRUCTION: made of high grade stainless steal and welded to perfection by one of our metal shops out here. backing plate is 1/4 inch and the latch bar is 1/4 inch in diameter.
will ship any here in the U.S. and i will post some pics when i get some more time. ive been real busy lately and ill try to check this page as much as possible. my e-mail is dopecivic94@yahoo.com
not too attached to any kind of payment. will trade, sell, what ever. lmk.
Thread
Thread Starter
Forum
Replies
Last Post




