My daily driver spun a bearing so I found a junkyard motor to replace it.

The original was a d16y5 vtec-e 5-spd motor with a p2n ecu. I used the original wiring harness from the car. The d16z6 was out of an auto. I have the p28 auto ecu.

What ecu should I run? Will the p2n work? Would the p28 auto work with a conversion harness? What about a p2p out of a 96+ civic. The 'new' motor is in the car waiting on fluids, and a distributor plug harness from rywire.

 

Try the 92-00 section, this is 06+

 

I saw the '6' and posted here... not paying attention!!

Can someone delete this? I've re posted in the right location.


Modified by SCedGSR at 5:47 PM 4/30/2008