It's a 1995 Civic coupe. I just need a few things straitened out and patched up.

Rear passenger size, has about a quarter size rust spot underneath.



Passenger side wheel well corner. Rust goes about 2 inches up the side:



Drivers side quarter panel, same rust as passenger side:



Drivers side between door and rear wheel well, hit and run indented panel, about 2" high, 1' long:




Passenger side, small dent, probably could be pulled out:

 

I'll be bringing it to a shop this weekend, just want to know a ballpark for the damage so I don't get screwed. Thanks in advance!

 

i have less damage then that and lowest estimate i got was for 1200, that was for both my bumpers, fenders and some tiny dings on the doors

 

I don't need it painted, so that should knock off alot. Just need the bodywork, thanks for the rough idea though!

 

id say minus paint your looking at close to $800, wouldnt be surprised at all if it was more.

 

I would say around a grand in primer( make sure its a 2K or epoxy primer)(and maybe ask them to tint the primer green)

 

Thanks for all the info guys!

 

dang i hate 1/4 panel damage

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by RC_Marshall &raquo;</TD></TR><TR><TD CLASS="quote">dang i hate 1/4 panel damage </TD></TR></TABLE>

Tell me about it It was a hit and run too, broke my heart

Had her since she was new off the lot in 96'. Probably one of the few that are original owners of an EJ2 on this site, kinda take pride in that She's worth the money, I've been trying to run her into the ground since around 2001 and she wouldn't die.....went 210k with no belt/gasket changes. Finally blew her head gasket around 215k, still drove 3k miles on a bad gasket.

She just got her B18c1, and ready to tear up the roads again! Might as well look good doing it