Hi all, I have a set of 2005 S2000 COP's I wish to use for a non-Honda project. They are Denso P/N: 099700-070 and have a 3 pin connector.

I have downloaded the S2000 service manual and have found that the wires going to the coils are:

Wht/Blu = Trigger from ECU
Blk/Yel = +12
Blk = Earth

The problem is that I don't have a coil harness to look at to see which wires go where in the connector, and the wiring diagram in the service manual does not give the pin numbers of the connector with the wire colors.

Could someone kindly steer me to a pinout diagram of the connector, or tell me from left to right, looking at the coil, which pin does what?

Thanks in advance!

 

hi looking from top
lh to rh

trigger gnd +12

 

even i am looking for the same thing but of no use tried in many places but unable to find it.

 

have you tried looking at the post above yours.