What should i expect to run with this setup?
Thread Starter
Honda-Tech Member
Joined: Jun 2002
Posts: 935
Likes: 0
From: Hot Ass, Arizona, united states
What should i expect to run with this setup?
b18a1 bottom end-ctr pistons on itr rods
b16a head-jun valvetrain and jun stage 3's
itr intake manifold
itr injectors
jun program p72 ecu redline 9100
apexi vafc
str cam gears
gsr oil pump
arp head studs and rod bolts
smsp or hytech header with greddy mx catback exhaust
that's pretty much it let me know what you think guys
b16a head-jun valvetrain and jun stage 3's
itr intake manifold
itr injectors
jun program p72 ecu redline 9100
apexi vafc
str cam gears
gsr oil pump
arp head studs and rod bolts
smsp or hytech header with greddy mx catback exhaust
that's pretty much it let me know what you think guys
Joined: May 2002
Posts: 374
Likes: 0
From: Garland, Texas, U.S.A
Re: What should i expect to run with this setup? (junya16)
That sounds like the average LS/VTEC setup. Do you have any plans for transmission mods? I'm guessing this car is going in an Integra, not a hatch(since it's in the Integra forum 
). With a good driver I'm estimating low 13's. Do you have money for all this?
). With a good driver I'm estimating low 13's. Do you have money for all this?
Thread Starter
Honda-Tech Member
Joined: Jun 2002
Posts: 935
Likes: 0
From: Hot Ass, Arizona, united states
Re: What should i expect to run with this setup? (B-series Assassin)
yeah i forgot to say i'm runnin a b16 tranny and i already have everything except the jun chip and thanks again for your reply
Thread Starter
Honda-Tech Member
Joined: Jun 2002
Posts: 935
Likes: 0
From: Hot Ass, Arizona, united states
Re: What should i expect to run with this setup? (ALLMOTORDC2)
if you don't like the subject don't read it, it's not that hard to pass over someone's post
Thread
Thread Starter
Forum
Replies
Last Post
LSVTEC ReX
All Motor / Naturally Aspirated
25
Aug 25, 2006 06:33 PM