Fully equipped with the safety.

what? nothing against the wall but a trash can!

cherry picker, D series, 2.4L, and snow tires

My pride and joy... also check out that table!!!! 1/4" plate steel is badass.

gorilla racks FTW

My neon

Gorilla rack in da back room FTW.

Jane and the little rack I made for her.

Entrance view

 

No more yellow foam dust FTW!

 

holy ****, no wonder your cherry picker cylinder is fubar lol

 

put some rustoleum on that engine crane... it seriously hurts my eyes sooo bad..

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by LordAphotic &raquo;</TD></TR><TR><TD CLASS="quote">put some rustoleum on that engine crane... it seriously hurts my eyes sooo bad..</TD></TR></TABLE>

No no it is a Rat Rod style engine lift.

 

hows that tool box workin out for ya. I've been lookin at the same one in the stainless finish.

 

The hoist is going back to the school...i used it to remove an engine/trans from my truck and the cylinder is toast. It sits outside..go figure its rusted.

The tool box is good... i had a kid run by my toolbox with the drawer open and he hit the side of the drawer with his quad....tweaked one drawer pretty good. ive been attempting to get it straightened, but that drawer always has some difficulty when you open it. I got mine for 180 bucks because it had a few minor scratches. (btw its the ball bearing one)

 

what is that a maxstar 200? dx, lx? how long have you had it and how much do you like it?

 

Its a dynasty 200dx. I sold my Syncrowave 200 and bought it in October. I run it on a 30amp breaker with no problems and it has all the bells and whistles I need. I got it for 2600 with 13 arc's and 1 minute of weld time (or something stupid low like that) Sold my syncrowave with 56minutes of welding and 24k strikes.


Modified by .RTErnie at 9:51 PM 1/3/2008

 

nice

 

whats this bellingham crap i see in your location eric? what happened to P town?

 

damn dude hook it up with a snail

 

Im going to WWU's Vehicle Research Institute getting my post bacc in "Race Engineering"

 

i spy dsm engine

 

loving the eastern

 

Damn. Back from the dead....lol

 

is that why it takes you 2 months to ship stuff out?
To busy taking pictues of yourself

 

Nice man I wish I could weld and had the fab skills that you do?

 

who keeps digging up all these old threads?

 

seriously. quit bringing back old stuff, unless your the poster. although eric makes some ballar manifolds fer sure.

 

I see you have 5 turbos sitting on the shelf how many more are you hiding?