New to the site!
I know this probably doesn't go here, but I wasn't sure where else to put it! Since I'm mostly into AutoXing at the moment (Club racing car in the works) I figured I'd throw it up here!
Just wanted to throw up a quick introduction! My name is Anthony, I'm 26 from Pittsburgh. I've been on RacePA.com for a long time, but figured I'd expand my horizions lol.
I have an 88' Civic hatch with a ZC swap using an Si tranny. It has a Centerforce pressure plate with an ACT clutch, a 7lb Fidanza aluminum flywheel, AEM intake, DC Sports 4-2-1 header through a Catco hi-flow cat, a 2 1/2" exaust to a Flowmaster 80 series muffler. It's lowered on an Eibach pro coilover-kit (500f/550r) and Koni Yellow's. Its got a 24mm Progress rear sway bar, and a Neuspeed front strut tower brace. It's gutted with a 6pt cage. It also has a Momo steering wheel.
I also have a 91' Civic hatch, also with a ZC swap. This one has a Centerforce dual-stage clutch, a 7lb aluminum flywheel, AEM intake, Airmass 4-2-1 header through a Catco hi-flow cat, a 2 1/4" Focuz cat-back exhaust. This one is lowered on H&R springs with KYB AGX struts. It has CRX Si front hubs/brakes, as well as the front & rear sway bars.
I've been autocrossing for about 4 years now. Guess that's it!
Just wanted to throw up a quick introduction! My name is Anthony, I'm 26 from Pittsburgh. I've been on RacePA.com for a long time, but figured I'd expand my horizions lol.
I have an 88' Civic hatch with a ZC swap using an Si tranny. It has a Centerforce pressure plate with an ACT clutch, a 7lb Fidanza aluminum flywheel, AEM intake, DC Sports 4-2-1 header through a Catco hi-flow cat, a 2 1/2" exaust to a Flowmaster 80 series muffler. It's lowered on an Eibach pro coilover-kit (500f/550r) and Koni Yellow's. Its got a 24mm Progress rear sway bar, and a Neuspeed front strut tower brace. It's gutted with a 6pt cage. It also has a Momo steering wheel.
I also have a 91' Civic hatch, also with a ZC swap. This one has a Centerforce dual-stage clutch, a 7lb aluminum flywheel, AEM intake, Airmass 4-2-1 header through a Catco hi-flow cat, a 2 1/4" Focuz cat-back exhaust. This one is lowered on H&R springs with KYB AGX struts. It has CRX Si front hubs/brakes, as well as the front & rear sway bars.
I've been autocrossing for about 4 years now. Guess that's it!
Thread
Thread Starter
Forum
Replies
Last Post
90civichbsi
Honda CRX / EF Civic (1988 - 1991)
2
Jan 31, 2005 06:46 AM
johnpowellcrx
Honda CRX / EF Civic (1988 - 1991)
6
Oct 5, 2004 09:23 PM



