TW / T / S> 1998 Acura Integra GS-R Sedan JDM front / 5x114
atleast $15k+ invested ... car value $5k
$14,999 buyout / obo.
may trade for 92-95 civic hb si mint condition + cash!
may trade for 92-95 civic hb si with swap / clean!! + cash
may trade for 96-00 civic with swap / clean!! + cash
or open offer
MUST HAVE P/S AND A/C!!! or atleast A/C!!!
first time it saw snow was december 1st of this month.
this car have no rust at all.
i pretty much got the clean title and reciept for body work and engine work.
So you know this car is legit.
Dec. 4th, just did tx title transferred to nj title
i believe it may take from a few weeks for the nj title to be mailed in.
from this point of time, title will be in soon!
this car is a work of art, simple yet tasteful~~
Dec. 27th, inspection sticker....... done, complete, good to go... woot! woot!
for those who want to check up on the car, vin JH4DB859XWS000827
--motor - freshly rebuilt from ground up about 8k++
built in arlington tx by REDLINE PERFORMANCE
built b18a1 LS bare block
p28 chipped turbo map (either skunk2 or jun)
hondata s200
type r water pump
type r oil pump
gsr pulley
b20 crank
eagle rods
JE pistons 9:1 compression pistons
BLUEPRINTED
2000 type R head complete / stock
2000 type R throttle body
golden eagle ls vtec kit
GSR tranny with LSD
ACT clutch and stage 2 pressure plate
new master and slave clutch cylinder
new stock axles.
walboro 255 fuel pump
780 precision injectors
golden eagle fuel rail
drag turbo manifold with a/c and p/s
t3/t4 garrett turbo barely to no shaft play on the turbo.
hks ssq blow-out valve.
tial 38mm wastegate
and a pretty big front mount. dont know the actual size.
3 inch down pipe all the way back to an apexi n1 turbo muffler
--exterior - body work / fresh paint several months ago.
cadillac pearl white
full 4dr optional kit
jdm type r frontend
jdm black housing headlights
jdm side marker
mks 10k HiD
shaved body side molding
shaved rear spoiler
shaved antenna
--interior - stock wear and tear (but no rip or holes)
gray leather seats
bezel w/ boost + lean air/fuel gauges
apexi black afc vtec controller
greddy spec 2 boost controller
alpine / kicker component?
pioneer head unit
custom homemade sub (im planning to throw it out)
rockford fosgate 500w amp
--suspension
skunk2 camber kits
skunk2 upper strut bar -UPDATED!- (stock gsr strut gone!)
gsr front lower sway bar
kyb adjustable shocks
ground control coilovers
ITR 5 lugs 5x114 conversion
16x7 Drag DR-16 +40 w/ brand new Falken 912 all-season (only 300+ miles on it)
--anti
clifford - alarm + turbo timer + fuel cut + remote start
i work 6 days a week and i only get sunday off. so please dont waste
my time nor yours.
best way to contact me is through aim or msn chat. leave me message(s)
and i reply when i can while i am at work or home.
aim - gamerchau
msn - gamerchau@hotmail.com
location - north jersey, 07419
yahoo map or map quest my location
to save a question, ty!
apexi n1 turbo ats - silencer

skunk2 upper strut bar

jdm h ctr cw 16 wheels are sold!





CAR LOOK WAY BETTER IN PERSON!!
Modified by Yeet-n-Duner at 11:42 AM 2/8/2008
$14,999 buyout / obo.
may trade for 92-95 civic hb si mint condition + cash!
may trade for 92-95 civic hb si with swap / clean!! + cash
may trade for 96-00 civic with swap / clean!! + cash
or open offer
MUST HAVE P/S AND A/C!!! or atleast A/C!!!
first time it saw snow was december 1st of this month.
this car have no rust at all.
i pretty much got the clean title and reciept for body work and engine work.
So you know this car is legit.
Dec. 4th, just did tx title transferred to nj title
i believe it may take from a few weeks for the nj title to be mailed in.
from this point of time, title will be in soon!
this car is a work of art, simple yet tasteful~~
Dec. 27th, inspection sticker....... done, complete, good to go... woot! woot!
for those who want to check up on the car, vin JH4DB859XWS000827
--motor - freshly rebuilt from ground up about 8k++
built in arlington tx by REDLINE PERFORMANCE
built b18a1 LS bare block
p28 chipped turbo map (either skunk2 or jun)
hondata s200
type r water pump
type r oil pump
gsr pulley
b20 crank
eagle rods
JE pistons 9:1 compression pistons
BLUEPRINTED
2000 type R head complete / stock
2000 type R throttle body
golden eagle ls vtec kit
GSR tranny with LSD
ACT clutch and stage 2 pressure plate
new master and slave clutch cylinder
new stock axles.
walboro 255 fuel pump
780 precision injectors
golden eagle fuel rail
drag turbo manifold with a/c and p/s
t3/t4 garrett turbo barely to no shaft play on the turbo.
hks ssq blow-out valve.
tial 38mm wastegate
and a pretty big front mount. dont know the actual size.
3 inch down pipe all the way back to an apexi n1 turbo muffler
--exterior - body work / fresh paint several months ago.
cadillac pearl white
full 4dr optional kit
jdm type r frontend
jdm black housing headlights
jdm side marker
mks 10k HiD
shaved body side molding
shaved rear spoiler
shaved antenna
--interior - stock wear and tear (but no rip or holes)
gray leather seats
bezel w/ boost + lean air/fuel gauges
apexi black afc vtec controller
greddy spec 2 boost controller
alpine / kicker component?
pioneer head unit
custom homemade sub (im planning to throw it out)
rockford fosgate 500w amp
--suspension
skunk2 camber kits
skunk2 upper strut bar -UPDATED!- (stock gsr strut gone!)
gsr front lower sway bar
kyb adjustable shocks
ground control coilovers
ITR 5 lugs 5x114 conversion
16x7 Drag DR-16 +40 w/ brand new Falken 912 all-season (only 300+ miles on it)
--anti
clifford - alarm + turbo timer + fuel cut + remote start
i work 6 days a week and i only get sunday off. so please dont waste
my time nor yours.
best way to contact me is through aim or msn chat. leave me message(s)
and i reply when i can while i am at work or home.
aim - gamerchau
msn - gamerchau@hotmail.com
location - north jersey, 07419
yahoo map or map quest my location
to save a question, ty!
apexi n1 turbo ats - silencer

skunk2 upper strut bar

jdm h ctr cw 16 wheels are sold!





CAR LOOK WAY BETTER IN PERSON!!
Modified by Yeet-n-Duner at 11:42 AM 2/8/2008
bahhhh!! i dont know how to blow up those pix up so ya' dont need to click on them.
but topic was updated with more info. include vin #
but topic was updated with more info. include vin #
thanks for the bump....
I MIGHT LOOK INTO A TRADE FROM WHAT I MENTIONED ABOVE
must have a/c and p/s!!!
I MIGHT LOOK INTO A TRADE FROM WHAT I MENTIONED ABOVE
must have a/c and p/s!!!
Trending Topics
had a few offers 10k+
some offered car + cash, but i didn't like them cars that much
keep it coming...
be real, any offer with cash only below $10k
dont bother wasting our time
MAYBE!!!, the guy was driving through south jersey, he was suppose to stop
by newark, but decided to dropped off my car instead.
woot! woot!, new set of wheels+tires will arrive today!!!
THANKS FOR ALL INTEREST, MANY OFFERS, SOME ARE NICE, KEEP IT COMING!
by newark, but decided to dropped off my car instead.
woot! woot!, new set of wheels+tires will arrive today!!!
THANKS FOR ALL INTEREST, MANY OFFERS, SOME ARE NICE, KEEP IT COMING!
Testing Water - $15,000 buyout / obo.
Selling if price is right
may trade for 92-95 civic hb si with swap / clean!! + cash
may trade for 96-00 civic with swap / clean!! + cash
MUST HAVE P/S AND A/C!!!
Selling if price is right
may trade for 92-95 civic hb si with swap / clean!! + cash
may trade for 96-00 civic with swap / clean!! + cash
MUST HAVE P/S AND A/C!!!
im not so sure, i will get the actual answer for you asap.
but the block and its internal was BLUEPRINTED. (crank, rod, pistons, etc.)
but the block and its internal was BLUEPRINTED. (crank, rod, pistons, etc.)
i just got the answer last night...
the block still has its original sleeves
it was bored out to certain spec. unsure.
nevertheless, as i said before. it is still safe to 20psi or 22psi
and the bottom end is BLUEPRINTED.
and the ecu is set at 17psi max.... play safe!
this motor is capable of 400+ whp, all u need to do is upgrade the turbo
(as u can see, there are more internal parts to play with also, i.e. head)
the block still has its original sleeves
it was bored out to certain spec. unsure.
nevertheless, as i said before. it is still safe to 20psi or 22psi
and the bottom end is BLUEPRINTED.
and the ecu is set at 17psi max.... play safe!
this motor is capable of 400+ whp, all u need to do is upgrade the turbo
(as u can see, there are more internal parts to play with also, i.e. head)
finally, my drag dr-16 16x7 wheels just came in...
http://www.dragwheels.com/product.asp?ID=35
need these on, upcoming monday hopefully if the weather is not
nasty, i will get it inspected!!
http://www.dragwheels.com/product.asp?ID=35
need these on, upcoming monday hopefully if the weather is not
nasty, i will get it inspected!!



breathe bump