TW/FS B18C5 POWERED HATCH!! white eh2! SOUTH CAROLINA!
Thread Starter
Member
Joined: Mar 2006
Posts: 1,509
Likes: 0
From: Flight of the Conchords
TW/FS B18C5 POWERED HATCH!! white eh2! SOUTH CAROLINA!
Make: Honda
Model: Civic
Year: 1992
Mileage: 140k
Options: CX model….What options? (A/C and P.locks)
Mods: Now this is gonna take awhile:
Interior:
Complete Blue to Black change over…
JDM Cluster
JDM Clock
JDM A/C controller
JDM center radio console
JDM Fog Light Switch/Defroster
Type R Shift boot
Type R glove box (lockable)
Dual Gauge pod
Carbon fiber boost gauge (autometer)
Carbon fiber Air/Fuel gauge (autometer)
JDM Type R momo steering Wheel (Just installed)
Power door looks installed
Spoon Shift ****
Broadway mirror
I love My Honda cling! (you know you like)
RSX blk floormats
Crappy pedal covers
Viper car alarm w/ keyless
Civic Type R Key
Alpine front Speakers
JDM Cluster
New Eg Si front seats
Exterior:
Fresh paint (factory frost white)
JDM antenna block off plate
Spoon style mirrors
JDM corner lenses(could use new pass. Side)
JDM HEADLIGHTS (city lights wired correctly)
8k HIDs...Highs and Lows
JDM ID tag
Grille-craft center insert
Factory foglights (blue look then lights up yellow, not wired)
VIS carbon fiber lip (cracked BAD)
J’s racing carbon fiber canards
Paint matched sideskirts
Paint matched doorhandles
NEW OEM MudFlaps
RAYS LUG NUTS
Susp./Wheels
GSR front brakes
GSR rear brakes
GSR front swaybar
GSR rear swaybar
GSR lower/upper control arms
EBC green pads front/rear
EBC rotors front/rear
Omni Power Track suspension (complete setup)
Tanabe Rear lower tie bar
Tanabe Sustec rear upper tie bar (Just installed)
Tanabe Sustec upper strut bar (Just installed)
Racing Hart CP-035C Wheels 15X6.5 with NEW NITTO NEOGEN (2wks old) 195/50/15 tires (competition wheels 7.9 lbs)
Ingalls camber kit front and rear
Engine (go fast stuff)
B18C5 fresh rings, bearings, head gasket, valve guides, etc…
JDM factory LSD GSR tranny w/ less than 20k
Toda Flywheel
BRAND NEW EXEDY CLUTCH(SERIOUSLY I JUST FINISHED INSTALLING IT) *ONLY 5 MILES ON IT
Skunk 2 intake manifold
Type R injectors
69 mm custom bored Tbody
Spoon Cam gears
Spoon Thermastat
Spoon Oil cap
Spoon socks
JDMPassword Carbon/Kevlar Wirecover
Spoon Valve cover (it’s not real)
New water pump, belt, etc…
AEM shortram intake
Pro1 2.5 header
Omni 2.5 Stainless cat
Buddy Club Pro Spec Exhaust
Odessey 680MJ Car Battery
Polished motor mounts
JDM Fuse cover
Type R proportional valve
Type R Master cylinder
Type R brake booster
P28 with chip
Engine: B18C5 w/ 3k miles
VIN#: 2HGEH2347NH******
Condition: I know that I left out some stuff, but will add as I remember. This car is in great condition! I only drive it on weekends and it is garage kept. This car was put together by me (Acura mechanic) and other Acura/Honda mechanic friends of mine. It is completely reliable. I just installed a new clutch.. cause the throw out bearing went out.. soo i replaces it with a exedy stage 1(basically oem) clutch. feels perfect.. if you come to look at the car.. i am not going to rev out the car, only reason is because the car needs to run for 500miles to break in the clutch.. if you buy the car, i 100% guarantee it will rev out to factory 8999 with no prob, and you will be 100% happy with the power.. i love this motor.. it is flawless.. plus the a/c is super cold!!! oo with the new clutch.. NEW CV AXLES, SLAVE, MASTER CYLINDER, CLUTCH, PRESSURE PLATE, THROW OUT BEARING, AND PILOT BEARING..
the only reason i am selling this, is because, for school.. makes me cry to think about it.. but my future is important!
trades wise... I AM ACCEPTING TRADES FOR DC2, EG, EG SI (NOT TEAL UNLESS IT HAS A K..HAHA), DC5, EM1, EK COUPE, EK..ALL CARS MUST HAVE A/C
I will take any trade plus cash, especially if its a eg si!
PRICE: I’ll start at $9000(please don't hate) but will take best offer… Motivated to sell!
CONTACT METHOD: erictulga@comcast.net
old pic
Modified by Rhymenoceros at 12:38 PM 12/5/2007
Modified by Rhymenoceros at 10:02 PM 12/20/2007
Model: Civic
Year: 1992
Mileage: 140k
Options: CX model….What options? (A/C and P.locks)
Mods: Now this is gonna take awhile:
Interior:
Complete Blue to Black change over…
JDM Cluster
JDM Clock
JDM A/C controller
JDM center radio console
JDM Fog Light Switch/Defroster
Type R Shift boot
Type R glove box (lockable)
Dual Gauge pod
Carbon fiber boost gauge (autometer)
Carbon fiber Air/Fuel gauge (autometer)
JDM Type R momo steering Wheel (Just installed)
Power door looks installed
Spoon Shift ****
Broadway mirror
I love My Honda cling! (you know you like)
RSX blk floormats
Crappy pedal covers
Viper car alarm w/ keyless
Civic Type R Key
Alpine front Speakers
JDM Cluster
New Eg Si front seats
Exterior:
Fresh paint (factory frost white)
JDM antenna block off plate
Spoon style mirrors
JDM corner lenses(could use new pass. Side)
JDM HEADLIGHTS (city lights wired correctly)
8k HIDs...Highs and Lows
JDM ID tag
Grille-craft center insert
Factory foglights (blue look then lights up yellow, not wired)
VIS carbon fiber lip (cracked BAD)
J’s racing carbon fiber canards
Paint matched sideskirts
Paint matched doorhandles
NEW OEM MudFlaps
RAYS LUG NUTS
Susp./Wheels
GSR front brakes
GSR rear brakes
GSR front swaybar
GSR rear swaybar
GSR lower/upper control arms
EBC green pads front/rear
EBC rotors front/rear
Omni Power Track suspension (complete setup)
Tanabe Rear lower tie bar
Tanabe Sustec rear upper tie bar (Just installed)
Tanabe Sustec upper strut bar (Just installed)
Racing Hart CP-035C Wheels 15X6.5 with NEW NITTO NEOGEN (2wks old) 195/50/15 tires (competition wheels 7.9 lbs)
Ingalls camber kit front and rear
Engine (go fast stuff)
B18C5 fresh rings, bearings, head gasket, valve guides, etc…
JDM factory LSD GSR tranny w/ less than 20k
Toda Flywheel
BRAND NEW EXEDY CLUTCH(SERIOUSLY I JUST FINISHED INSTALLING IT) *ONLY 5 MILES ON IT
Skunk 2 intake manifold
Type R injectors
69 mm custom bored Tbody
Spoon Cam gears
Spoon Thermastat
Spoon Oil cap
Spoon socks
JDMPassword Carbon/Kevlar Wirecover
Spoon Valve cover (it’s not real)
New water pump, belt, etc…
AEM shortram intake
Pro1 2.5 header
Omni 2.5 Stainless cat
Buddy Club Pro Spec Exhaust
Odessey 680MJ Car Battery
Polished motor mounts
JDM Fuse cover
Type R proportional valve
Type R Master cylinder
Type R brake booster
P28 with chip
Engine: B18C5 w/ 3k miles
VIN#: 2HGEH2347NH******
Condition: I know that I left out some stuff, but will add as I remember. This car is in great condition! I only drive it on weekends and it is garage kept. This car was put together by me (Acura mechanic) and other Acura/Honda mechanic friends of mine. It is completely reliable. I just installed a new clutch.. cause the throw out bearing went out.. soo i replaces it with a exedy stage 1(basically oem) clutch. feels perfect.. if you come to look at the car.. i am not going to rev out the car, only reason is because the car needs to run for 500miles to break in the clutch.. if you buy the car, i 100% guarantee it will rev out to factory 8999 with no prob, and you will be 100% happy with the power.. i love this motor.. it is flawless.. plus the a/c is super cold!!! oo with the new clutch.. NEW CV AXLES, SLAVE, MASTER CYLINDER, CLUTCH, PRESSURE PLATE, THROW OUT BEARING, AND PILOT BEARING..
the only reason i am selling this, is because, for school.. makes me cry to think about it.. but my future is important!
trades wise... I AM ACCEPTING TRADES FOR DC2, EG, EG SI (NOT TEAL UNLESS IT HAS A K..HAHA), DC5, EM1, EK COUPE, EK..ALL CARS MUST HAVE A/C
I will take any trade plus cash, especially if its a eg si!
PRICE: I’ll start at $9000(please don't hate) but will take best offer… Motivated to sell!
CONTACT METHOD: erictulga@comcast.net
old pic
Modified by Rhymenoceros at 12:38 PM 12/5/2007
Modified by Rhymenoceros at 10:02 PM 12/20/2007
Trending Topics
Honda-Tech Member
Joined: Oct 2006
Posts: 45
Likes: 0
From: New Orleans, La, USA
Re: B18C
Are you interested in selling the engine? Let me know, flybmxer4130@vampirefreaks.com
Thanks
Thanks
Thread Starter
Member
Joined: Mar 2006
Posts: 1,509
Likes: 0
From: Flight of the Conchords
Re: TW/FS B18C5 POWERED HATCH!! white eh2! SOUTH CAROLINA! (d16vteceg)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by d16vteceg »</TD></TR><TR><TD CLASS="quote">Gorgeous, absolutely gorgeous. I will be keeping my eye on this one...</TD></TR></TABLE>
thanks man
thanks man