Looking for a built LS bottom end ready for turbo, not looking for any sleeved blocks, just rod/piston combo, with new rod bolts/bearings etc. Post up what you have!

 

Name: Gerald
Location: Virginia Beach, VA
Shipping: Buyer will pay extra for the shipping charges
Contact: Feel free to call : 757-971-2414

This comes with ALL sensors in good working condition. *** THERE ARE ABSOLUTELY ZERO LEAKS ON THIS SWAP***. I pulled this out of my car 11/15/2007 after the rebuild at 12,462 miles..

---Oil was changed every 1000 miles since I rarely pulled my car out of the garage.. I've always used genuine Honda Oil Filters from the dealership.

$2500 OBO For Everything Listed

-Darton Sleeved B18a block and head

-JE 8.5 pistons

-Crower Rods

-Cometic High Pressure head gasket

-ARP Head Studs

-JG EdelBrock Intake Manifold

-AEM Fuel Pressure Regulator

-Precision 880cc Injectors

-Edelbrock Pro Flo Fuel rail 5/8" bore

-Skunk 2 Cam Gears

-MSD plug Wires

-ITR Oil Pump

-B&M Fuel Pressure Gauge

-Hondata Intake Manifold Gasket --ordered brand new off Inlinefour.com

-LS Tranny -- ZERO Grinds

**Misc. - New Oil Pan gasket, may not come with MSD cap
*****Will not come with--Axles(snapped) Wire harness(need for next swap)

NO TRADES/NOT PARTING OUT

 

man too bad you wasnt around a month ago before i decided to keep my block
http://www.hondamarketplace.co...25316

 

Got an LS Block: Roughly 2000 Miles since build-Only used as spare motor while
other block was being sleeved


Ls Block
81.5mm Endyn Roller Wave Pistons 11.5:1
Eagle Rods
Type R Oil Pump
Type R Water Pump
ARP Headstuds
LS-Vtec Line

Looking for 1200 obo.

Located in New York

Thanks,
Justin

 

txt me asap have built b18a1 eagle rods cp pistons 9;1 550 im in virginia.....fresh beck arnley rod bearings...txt me at 540 219 0806