Putting stock header back to mate to aftermarket exhaust.... need bolt sizing for teg
Thread Starter
Honda-Tech Member
Joined: May 2001
Posts: 5,089
Likes: 1
From: Trinidad, W.I.
Putting stock header back to mate to aftermarket exhaust.... need bolt sizing for teg
It's a 97 B18B in a 4d teg...
I need repairs, so I need to bolt back in my stock header for a while.
I have a custom exhaust (not a name brand) and will need to have it cut and flanged to meet the stock header. Now when bolting the header to the cat in a stock configuration, one would normally use spring loaded exhaust bolts from factory... my problem is that I don't have 'em. Do I have to use the stockers or can I buy a pair from the parts store ? If so, what length would I need to get ?
Any info would be greatly appreciated.
X2
I need repairs, so I need to bolt back in my stock header for a while.
I have a custom exhaust (not a name brand) and will need to have it cut and flanged to meet the stock header. Now when bolting the header to the cat in a stock configuration, one would normally use spring loaded exhaust bolts from factory... my problem is that I don't have 'em. Do I have to use the stockers or can I buy a pair from the parts store ? If so, what length would I need to get ?Any info would be greatly appreciated.
X2
Thread
Thread Starter
Forum
Replies
Last Post
X2BOARD
Acura Integra
4
Jun 26, 2002 06:14 AM
