Notices
Vehicles for sale Post vehicles for sale only

FS/FT-JDM SPEC MR DC2 TX

Thread Tools
 
Search this Thread
 
Old Oct 11, 2007 | 08:16 AM
  #1  
honinspire02's Avatar
Thread Starter
Honda-Tech Member
 
Joined: Oct 2006
Posts: 375
Likes: 0
From: el paso, tx, usa
Default FS/FT-JDM SPEC MR DC2 TX

ok guys i think it has come time to move on to another project... this has been my baby for the past year and a half.... i am the third owner and the car does have a clean title... i will be quite honest over the past year and a half the car has mainly sat in the garage and only taken out on weekends and on nice days... if you are looking for a normal everyday car this is not the car for you... anyways now time for the goodies:

95 integra gsr with 140k chasis and 2000-3000 miles on motor

Exterior:

Allmetal Jdm ITR Frontend (2000.00)
Brand new Dc2 black housing headlights(790.00)
Shaved door moldings
painted mr original factory color in 10-11/06 ($2600.00)
side skirts also matched
jdm itr lip
all red rear tail lights
oem mud flaps
reap wiper delete
JDM Sirg badges
16in Volk Te 37 with Yokohama Parada II
i believe thats about it but i may be forgetting a few items...

Interior:

JDM black ITR Recaros
JDM ITR Door Panels
JDM ITR armrest
JDM ITR Shift boot
JDM ITR Climate Control
JDM ITR ashtray
JDM ITR cupholder
JDM Clock blockoff
JDM ITR Window switches
Jdm ITR door handles
JDM ITR Foglight Switch
Authentic Mugen Dc2 Cluster w/5600 km
JDM ITR Floor mats
Jdm ITR rear seat
Skunk 2 weighted shift ****
Skunk 2 short shifter
Broadway mirror

Chasis/Suspension:

Brand new F2 18 way adjustable suspension (2 months)
s2 camber kit all the way around
Spoon froont strut bar
spoon rear strut bar
spoon lower rear tie bar
Jdm C pillar bar
brand new driveshafts (both sides)
powerslot cross drilled and slotted rotors
hawk brake pads
new oem master cylinder
Avid motor mounts

Engine: (only 2500 miles since build)

B18c1 block
CTR Pistons (81.5)
Gsr rods
oem bearings
oem head gasket
all new gaskets and seals
gsr head w/ port and polish
buddyclub valves springs and retainers
buddyclub spec IV cams
toda cam gears
ngk g power plugs
ngk wires
new timing belt
rc 310 injectors
imerj fuel rail
fuel pressure regulater
walbro 255 fuel pump
skunk2 68mm intake manifold
RPM 70mm TB
hondata intake manifold gasket
Koyo aluminum full size radiatior
2 slim fans
lower temperature thermostat
buddyclub fan switch
hytech replica header
skunk 2 cat back exhaust
gsr tranny w lsd (no grinds only use honda mtl)
exedy organic race clutch and p.p.
act lightened flywheel
obd1 p72 w/ hondata s300 tuned
i'm sure theres more but at the moment this all i can remember...

misc:
jvc deck
polk 6.5 2 way in the frnt door
pioneer 3 way in the back
1 12in kicker sub
1 1200 watt amp
1 800 watt amp
1 capicator

well this is my baby i will be taking offers and possible trades plus cash depending on what it is.... all lowballs offers will be ignored.... for more info pm me.... also should have some pics up later cause cant figure out how to post them.. but i can email them to you before if you'd like.... please bare in mind that this car has been well taken care of and will be very hard to part with and has always ran synthetic motor oil in it as well as 91 octane.... i have invested over 26000 dollars in to it and it will be sold takin a loss so lmk if i can help in any other way... thanks for looking... and please keep all negative comments to your self...




Modified by honinspire02 at 11:53 AM 10/11/2007
Old Oct 11, 2007 | 10:00 AM
  #2  
honinspire02's Avatar
Thread Starter
Honda-Tech Member
 
Joined: Oct 2006
Posts: 375
Likes: 0
From: el paso, tx, usa
Default Re: FS/FT-JDM SPEC MR DC2 TX (honinspire02)

oh yeah forgot to mention it is a clean title car never been in any accident... pics coming later on...
Old Oct 11, 2007 | 12:27 PM
  #3  
honinspire02's Avatar
Thread Starter
Honda-Tech Member
 
Joined: Oct 2006
Posts: 375
Likes: 0
From: el paso, tx, usa
Default Re: FS/FT-JDM SPEC MR DC2 TX (honinspire02)








Old Oct 11, 2007 | 12:28 PM
  #4  
honinspire02's Avatar
Thread Starter
Honda-Tech Member
 
Joined: Oct 2006
Posts: 375
Likes: 0
From: el paso, tx, usa
Default Re: FS/FT-JDM SPEC MR DC2 TX (honinspire02)

more pics later after car is cleaned.... and also engine bay shots...
Old Oct 11, 2007 | 01:05 PM
  #5  
kptrulee's Avatar
Honda-Tech Member
iTrader: (2)
 
Joined: Mar 2003
Posts: 11,043
Likes: 0
From: D-TOWN IOWA!
Default Re: FS/FT-JDM SPEC MR DC2 TX (honinspire02)

wingless jdm front dc2
gl with the sale, great guy
Old Oct 11, 2007 | 01:22 PM
  #6  
Thrule01's Avatar
Honda-Tech Member
 
Joined: May 2006
Posts: 1,163
Likes: 0
From: Abbeville/Lafayette, LA, USA
Default

very clean what you looking to fetch price wise?
Old Oct 11, 2007 | 04:24 PM
  #7  
honinspire02's Avatar
Thread Starter
Honda-Tech Member
 
Joined: Oct 2006
Posts: 375
Likes: 0
From: el paso, tx, usa
Default Re: FS/FT-JDM SPEC MR DC2 TX (honinspire02)

not real sure takin offers at the moment... i guess the it sits with all the parts we'll shoot for 14000.00 obo... of course i am willing to trade shell for shell or cars if its of equal value..... lets get some offers show what you all got....
Old Oct 12, 2007 | 04:29 PM
  #8  
honinspire02's Avatar
Thread Starter
Honda-Tech Member
 
Joined: Oct 2006
Posts: 375
Likes: 0
From: el paso, tx, usa
Default Re: FS/FT-JDM SPEC MR DC2 TX (honinspire02)

bump
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
socal_93 Si
Vehicles for sale
27
Sep 23, 2008 09:21 AM
MR RHD
Vehicles for sale
10
Aug 12, 2008 12:39 PM
MR RHD
Southern California (Sales)
7
Jul 27, 2008 02:11 PM
honinspire02
Texas -OK -LA (Sales)
26
Nov 16, 2007 11:33 AM
SickWitIt2.0
For Sale
3
Apr 15, 2006 06:10 AM




All times are GMT -8. The time now is 10:12 PM.