FS/FT-JDM SPEC MR DC2 TX
Thread Starter
Honda-Tech Member
Joined: Oct 2006
Posts: 375
Likes: 0
From: el paso, tx, usa
FS/FT-JDM SPEC MR DC2 TX
ok guys i think it has come time to move on to another project... this has been my baby for the past year and a half.... i am the third owner and the car does have a clean title... i will be quite honest over the past year and a half the car has mainly sat in the garage and only taken out on weekends and on nice days... if you are looking for a normal everyday car this is not the car for you... anyways now time for the goodies:
95 integra gsr with 140k chasis and 2000-3000 miles on motor
Exterior:
Allmetal Jdm ITR Frontend (2000.00)
Brand new Dc2 black housing headlights(790.00)
Shaved door moldings
painted mr original factory color in 10-11/06 ($2600.00)
side skirts also matched
jdm itr lip
all red rear tail lights
oem mud flaps
reap wiper delete
JDM Sirg badges
16in Volk Te 37 with Yokohama Parada II
i believe thats about it but i may be forgetting a few items...
Interior:
JDM black ITR Recaros
JDM ITR Door Panels
JDM ITR armrest
JDM ITR Shift boot
JDM ITR Climate Control
JDM ITR ashtray
JDM ITR cupholder
JDM Clock blockoff
JDM ITR Window switches
Jdm ITR door handles
JDM ITR Foglight Switch
Authentic Mugen Dc2 Cluster w/5600 km
JDM ITR Floor mats
Jdm ITR rear seat
Skunk 2 weighted shift ****
Skunk 2 short shifter
Broadway mirror
Chasis/Suspension:
Brand new F2 18 way adjustable suspension (2 months)
s2 camber kit all the way around
Spoon froont strut bar
spoon rear strut bar
spoon lower rear tie bar
Jdm C pillar bar
brand new driveshafts (both sides)
powerslot cross drilled and slotted rotors
hawk brake pads
new oem master cylinder
Avid motor mounts
Engine: (only 2500 miles since build)
B18c1 block
CTR Pistons (81.5)
Gsr rods
oem bearings
oem head gasket
all new gaskets and seals
gsr head w/ port and polish
buddyclub valves springs and retainers
buddyclub spec IV cams
toda cam gears
ngk g power plugs
ngk wires
new timing belt
rc 310 injectors
imerj fuel rail
fuel pressure regulater
walbro 255 fuel pump
skunk2 68mm intake manifold
RPM 70mm TB
hondata intake manifold gasket
Koyo aluminum full size radiatior
2 slim fans
lower temperature thermostat
buddyclub fan switch
hytech replica header
skunk 2 cat back exhaust
gsr tranny w lsd (no grinds only use honda mtl)
exedy organic race clutch and p.p.
act lightened flywheel
obd1 p72 w/ hondata s300 tuned
i'm sure theres more but at the moment this all i can remember...
misc:
jvc deck
polk 6.5 2 way in the frnt door
pioneer 3 way in the back
1 12in kicker sub
1 1200 watt amp
1 800 watt amp
1 capicator
well this is my baby i will be taking offers and possible trades plus cash depending on what it is.... all lowballs offers will be ignored.... for more info pm me.... also should have some pics up later cause cant figure out how to post them.. but i can email them to you before if you'd like.... please bare in mind that this car has been well taken care of and will be very hard to part with and has always ran synthetic motor oil in it as well as 91 octane.... i have invested over 26000 dollars in to it and it will be sold takin a loss so lmk if i can help in any other way... thanks for looking... and please keep all negative comments to your self...
Modified by honinspire02 at 11:54 AM 10/11/2007
95 integra gsr with 140k chasis and 2000-3000 miles on motor
Exterior:
Allmetal Jdm ITR Frontend (2000.00)
Brand new Dc2 black housing headlights(790.00)
Shaved door moldings
painted mr original factory color in 10-11/06 ($2600.00)
side skirts also matched
jdm itr lip
all red rear tail lights
oem mud flaps
reap wiper delete
JDM Sirg badges
16in Volk Te 37 with Yokohama Parada II
i believe thats about it but i may be forgetting a few items...
Interior:
JDM black ITR Recaros
JDM ITR Door Panels
JDM ITR armrest
JDM ITR Shift boot
JDM ITR Climate Control
JDM ITR ashtray
JDM ITR cupholder
JDM Clock blockoff
JDM ITR Window switches
Jdm ITR door handles
JDM ITR Foglight Switch
Authentic Mugen Dc2 Cluster w/5600 km
JDM ITR Floor mats
Jdm ITR rear seat
Skunk 2 weighted shift ****
Skunk 2 short shifter
Broadway mirror
Chasis/Suspension:
Brand new F2 18 way adjustable suspension (2 months)
s2 camber kit all the way around
Spoon froont strut bar
spoon rear strut bar
spoon lower rear tie bar
Jdm C pillar bar
brand new driveshafts (both sides)
powerslot cross drilled and slotted rotors
hawk brake pads
new oem master cylinder
Avid motor mounts
Engine: (only 2500 miles since build)
B18c1 block
CTR Pistons (81.5)
Gsr rods
oem bearings
oem head gasket
all new gaskets and seals
gsr head w/ port and polish
buddyclub valves springs and retainers
buddyclub spec IV cams
toda cam gears
ngk g power plugs
ngk wires
new timing belt
rc 310 injectors
imerj fuel rail
fuel pressure regulater
walbro 255 fuel pump
skunk2 68mm intake manifold
RPM 70mm TB
hondata intake manifold gasket
Koyo aluminum full size radiatior
2 slim fans
lower temperature thermostat
buddyclub fan switch
hytech replica header
skunk 2 cat back exhaust
gsr tranny w lsd (no grinds only use honda mtl)
exedy organic race clutch and p.p.
act lightened flywheel
obd1 p72 w/ hondata s300 tuned
i'm sure theres more but at the moment this all i can remember...
misc:
jvc deck
polk 6.5 2 way in the frnt door
pioneer 3 way in the back
1 12in kicker sub
1 1200 watt amp
1 800 watt amp
1 capicator
well this is my baby i will be taking offers and possible trades plus cash depending on what it is.... all lowballs offers will be ignored.... for more info pm me.... also should have some pics up later cause cant figure out how to post them.. but i can email them to you before if you'd like.... please bare in mind that this car has been well taken care of and will be very hard to part with and has always ran synthetic motor oil in it as well as 91 octane.... i have invested over 26000 dollars in to it and it will be sold takin a loss so lmk if i can help in any other way... thanks for looking... and please keep all negative comments to your self...
Modified by honinspire02 at 11:54 AM 10/11/2007
Trending Topics
Honda-Tech Member
Joined: Mar 2002
Posts: 6,295
Likes: 0
From: 106 and Park
Re: FS/FT-JDM SPEC MR DC2 TX (honinspire02)
bump for e.p. I might be moving back to the area. I don't think I would ever want to live in e.p., but i might move to New Mexico. Nice car, good luck on the sale.
ME LOVE U LONG TIME
Joined: Jul 2005
Posts: 2,246
Likes: 0
From: Dallas, Tx
Re: FS/FT-JDM SPEC MR DC2 TX (honinspire02)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by honinspire02 »</TD></TR><TR><TD CLASS="quote">price with out rims and recaros 4000 obo... lmk if you need more info drop me a pm with your number</TD></TR></TABLE>
you dropped the price from 14 to 4 grand.... WTF dude..you only asking 4k without the rims and seats... ?
you dropped the price from 14 to 4 grand.... WTF dude..you only asking 4k without the rims and seats... ?
