96 civic hatch_K20R swap *Original Honda paint* Southern California*************
Thread Starter
Honda-Tech Member
iTrader: (2)
Joined: Nov 2002
Posts: 11,076
Likes: 0
From: San Pedro, CA
<FONT SIZE="1">You are looking at a super mint ek with a K20R swap. I bought this car bone stock in January this year from Gardena Honda, it had 79k on the clock and now has about 85k miles. The vehicle is in superb condition in and out. It has the original coat of paint from Honda (Not to common these days) and it still shines nice n bright. The vehicle has not seen any type of collision, everything lines up perfectly, in fact, it has no dents with exception of a couple tiny dings. Everything on the exterior is oem Honda down to the original windows with the secure etch engraving on them. The interior is in mint condition! nice and dry with no scratches all the way back to the trunk area. It has NEVER BEEN GUTTED, in fact, I still have the spare tire intact. <U>THE CAR FEELS NICE AND FIRM JUST LIKE A STOCK TYPE R!</U>
I performed the K20R swap just last month, this is my second K swap so I felt comfortable doing so. The complete swap was pulled out of my old ek, Rcrew racing (in Northern California) performed the original swap (into my old car) so I still have the reciept for the original swap (10k after Kpro)
The swap has been pampered using only Honda fluids down the the coolant. The swap is very clean, I made sure everything fit with proper brackets where they were needed, the shifter box was even mounted over the tunnel so that no cutting would be involved (I used the Rcrew shifter mount, only drilled two tiny 5mm holes) to sum it up; very clean swap
<U>Vehicle:</U>
-1996 Honda civic cx (lightest model and year) clean title
<U>Color</U>: Vogue Silver Metallic (Original coat of paint from Honda)
<U>Motor:</U>
-K20A-R (Integra type R, VERY LOW MILES ON MOTOR!!!) complete swap:
-Hondata KPRO
-Rcrew 400hp axles (babied like everything else)
-Rcrew race header
-Rcrew PNP hanress
-EP3 pulley
-Profab intake manifold gasket
-Hasport ekk2 motor mounts| two settings (steet inserts)
-Powder coated mount brackets
-ITR front sub-frame
-AEM intake
-3" catback:
-3" Kteller mandrel piping
-3" magnaflow highflow catalytic converter
-3" Dynomax super turbo muffler
-3" turndown (deep tone not high pitch)
-Koyo half size radiator
-Hasport radiator hose insert
-brand new oem 02 sensor
-AEM fuel rail
-AEM FPR
-Steel braided fuel lines
-will NOT come with rbc manifold in pictures, will have the original prc
<U>Exterior</U>:
-Oem SIR/ek4 headlights (purchased brand new)
-Oem SIR/ek4 lip (purchased brand new)
-Oem vsm dx wing
-Brand new door sill moldings
-Brand new roof moldings
-Brand new door pillars
<U>Transmission</U>:
-Oem DC5 6spd
-DC5 clutch
<U>Interior</U>:
-Buddyclub short shifter box (You can adjust the throws, make them shorter or longer, purchased brand new less than 1 month ago)
-Oem DC5 shiftknob
-LS light grey seats (mint, match interior very well)
<U>-WILL NOT COME WITH SPOON STEERING WHEEL, DONT ASK! but I will include the mint oem steering wheel.
-WILL NOT COME WITH SPOON CLUSTER, DONT ASK! but i will include the oem cluster.</U>
<U>Suspension</U>:
-Integra type R front sway bar
-Integra type R rear swaybar
-Integra type R front sub-frame
-Integra type R front LCA's
-Integra TR shock forks
-ASR rear reinforcement kit
-Spoon rear lower tie-bar
-Tokico HP shocks
-H&R sport springs
-Skunk2 front camber kit
-CAR HANDLES AMAZING!
<U>Wheels</U>:
-Spoon sports sw388's| 15x6.5|+45 offset
-Tires: Bridgestone potenza RE750| 205/50/15
<U>Steering</U>:
-Integra type R steering rack (shorter turning radius)
<U>Brakes</U>:
-NSX master cylinder
-Integra type R Brake booster
</FONT><U><FONT COLOR="blue"><FONT SIZE="10">- SOLD!!!</FONT></FONT></U>
<FONT SIZE="3"><U>Contact</U>:
-Kenny
-Email: eg6ken@yahoo.com
-AIM: thetightside
The vehicle is located in Southern California but I am willing to ship it anywhere in the Country. Test drives will only be available to those that show me the money!
I understand that a K car can be had for less $$, but it will not be as clean, you will most likely have to invest in paint and probably a mild restoration which =cheddar!
<FONT COLOR="red"><U>Please, please, serious buyers only!!!</U></FONT>
<U>Here are the pictures:</U></FONT>

















Modified by ken-e at 7:42 PM 10/15/2007
I performed the K20R swap just last month, this is my second K swap so I felt comfortable doing so. The complete swap was pulled out of my old ek, Rcrew racing (in Northern California) performed the original swap (into my old car) so I still have the reciept for the original swap (10k after Kpro)
The swap has been pampered using only Honda fluids down the the coolant. The swap is very clean, I made sure everything fit with proper brackets where they were needed, the shifter box was even mounted over the tunnel so that no cutting would be involved (I used the Rcrew shifter mount, only drilled two tiny 5mm holes) to sum it up; very clean swap
<U>Vehicle:</U>
-1996 Honda civic cx (lightest model and year) clean title
<U>Color</U>: Vogue Silver Metallic (Original coat of paint from Honda)
<U>Motor:</U>
-K20A-R (Integra type R, VERY LOW MILES ON MOTOR!!!) complete swap:
-Hondata KPRO
-Rcrew 400hp axles (babied like everything else)
-Rcrew race header
-Rcrew PNP hanress
-EP3 pulley
-Profab intake manifold gasket
-Hasport ekk2 motor mounts| two settings (steet inserts)
-Powder coated mount brackets
-ITR front sub-frame
-AEM intake
-3" catback:
-3" Kteller mandrel piping
-3" magnaflow highflow catalytic converter
-3" Dynomax super turbo muffler
-3" turndown (deep tone not high pitch)
-Koyo half size radiator
-Hasport radiator hose insert
-brand new oem 02 sensor
-AEM fuel rail
-AEM FPR
-Steel braided fuel lines
-will NOT come with rbc manifold in pictures, will have the original prc
<U>Exterior</U>:
-Oem SIR/ek4 headlights (purchased brand new)
-Oem SIR/ek4 lip (purchased brand new)
-Oem vsm dx wing
-Brand new door sill moldings
-Brand new roof moldings
-Brand new door pillars
<U>Transmission</U>:
-Oem DC5 6spd
-DC5 clutch
<U>Interior</U>:
-Buddyclub short shifter box (You can adjust the throws, make them shorter or longer, purchased brand new less than 1 month ago)
-Oem DC5 shiftknob
-LS light grey seats (mint, match interior very well)
<U>-WILL NOT COME WITH SPOON STEERING WHEEL, DONT ASK! but I will include the mint oem steering wheel.
-WILL NOT COME WITH SPOON CLUSTER, DONT ASK! but i will include the oem cluster.</U>
<U>Suspension</U>:
-Integra type R front sway bar
-Integra type R rear swaybar
-Integra type R front sub-frame
-Integra type R front LCA's
-Integra TR shock forks
-ASR rear reinforcement kit
-Spoon rear lower tie-bar
-Tokico HP shocks
-H&R sport springs
-Skunk2 front camber kit
-CAR HANDLES AMAZING!
<U>Wheels</U>:
-Spoon sports sw388's| 15x6.5|+45 offset
-Tires: Bridgestone potenza RE750| 205/50/15
<U>Steering</U>:
-Integra type R steering rack (shorter turning radius)
<U>Brakes</U>:
-NSX master cylinder
-Integra type R Brake booster
</FONT><U><FONT COLOR="blue"><FONT SIZE="10">- SOLD!!!</FONT></FONT></U>
<FONT SIZE="3"><U>Contact</U>:
-Kenny
-Email: eg6ken@yahoo.com
-AIM: thetightside
The vehicle is located in Southern California but I am willing to ship it anywhere in the Country. Test drives will only be available to those that show me the money!
I understand that a K car can be had for less $$, but it will not be as clean, you will most likely have to invest in paint and probably a mild restoration which =cheddar!
<FONT COLOR="red"><U>Please, please, serious buyers only!!!</U></FONT>
<U>Here are the pictures:</U></FONT>
Modified by ken-e at 7:42 PM 10/15/2007
Thread Starter
Honda-Tech Member
iTrader: (2)
Joined: Nov 2002
Posts: 11,076
Likes: 0
From: San Pedro, CA
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mr.OB*GYN_Rhett »</TD></TR><TR><TD CLASS="quote">******* legit
</TD></TR></TABLE>Rhett got to see this baby over the weekend and got a taste of the K-wrath so he can vouch
</TD></TR></TABLE>Rhett got to see this baby over the weekend and got a taste of the K-wrath so he can vouch
Trending Topics
Thread Starter
Honda-Tech Member
iTrader: (2)
Joined: Nov 2002
Posts: 11,076
Likes: 0
From: San Pedro, CA
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mr.OB*GYN_Rhett »</TD></TR><TR><TD CLASS="quote">thats very true and OMFG lol
</TD></TR></TABLE><TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mr.OB*GYN_Rhett »</TD></TR><TR><TD CLASS="quote">thats very true and OMFG lol
</TD></TR></TABLE><TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mr.OB*GYN_Rhett »</TD></TR><TR><TD CLASS="quote">thats very true and OMFG lol
</TD></TR></TABLE><TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mr.OB*GYN_Rhett »</TD></TR><TR><TD CLASS="quote">thats very true and OMFG lol
</TD></TR></TABLE>
</TD></TR></TABLE><TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mr.OB*GYN_Rhett »</TD></TR><TR><TD CLASS="quote">thats very true and OMFG lol
</TD></TR></TABLE><TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mr.OB*GYN_Rhett »</TD></TR><TR><TD CLASS="quote">thats very true and OMFG lol
</TD></TR></TABLE><TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mr.OB*GYN_Rhett »</TD></TR><TR><TD CLASS="quote">thats very true and OMFG lol
</TD></TR></TABLE>
the son and the heir
iTrader: (1)
Joined: Jun 2003
Posts: 13,698
Likes: 0
From: dreaming of the Gulf Coast, USA
damn kenny, if i had 13k and an extra garage spot, this would be the car i purchase.
dope.
dope.
Thread Starter
Honda-Tech Member
iTrader: (2)
Joined: Nov 2002
Posts: 11,076
Likes: 0
From: San Pedro, CA
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by macrosshn »</TD></TR><TR><TD CLASS="quote">damn kenny, if i had 13k and an extra garage spot, this would be the car i purchase.
dope.
</TD></TR></TABLE>
dope.
</TD></TR></TABLE>
Thread Starter
Honda-Tech Member
iTrader: (2)
Joined: Nov 2002
Posts: 11,076
Likes: 0
From: San Pedro, CA
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by AllmotorEg13203 »</TD></TR><TR><TD CLASS="quote">i think im in love!! if i lived out there, i would buy this car so quick... beautiful car,great work!</TD></TR></TABLE>Shipping is available
the son and the heir
iTrader: (1)
Joined: Jun 2003
Posts: 13,698
Likes: 0
From: dreaming of the Gulf Coast, USA
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by ken-e »</TD></TR><TR><TD CLASS="quote">Shipping is available
</TD></TR></TABLE>
</TD></TR></TABLE>


